Manual

35
Upper Plate + Thigh Joint
Note: Through the assembly below, please keep the power ON and the servos CONNECTED
1. Connect the servo rocker arm and the servo
with servo screws.
(Packaged with the servo, the servo screw is
the shortest one among the three.)
The directions of all components must be
exactly the same with the following picture:
2. Tighten the screws. Pay attention
that in the whole course of the
subsequent assembly, the shaft of
the unconnected servos should be
outward.
3. After connection, the top view is as follows. Please pay attention to the direction of
these components. Try your best to make it close to the following picture. But if there is
SunFounder