Manualshelf

User Manual

ManualsBrandsSunFounder ManualsComputers & AccessoriesRaspberry Pi 4 Model B Starter Kit Super Kit for RPi 400 4B 3B+ 3B 2B B+ A+ Zero Including GPIO Breakout Board Breadboard LCD DC Motor LED RGB Dot Matrix 73 Page Manual User Guide
70717273747576777879
Table Of Contents
73
6. Set WebIOPi to start with the system
sudo update-rc.d webiopi defaults
7. Open the interface of IP address access management with a browser
http://192.168.1.106:8000/webiopi/
Control method
1) Click the outside IN/OUT to switch between the input and output modes of GPIOs
2) In the output mode, click the inside figures to switch between high and low outputs.
After connecting the LED to GPIO17, click block 11, and you will see the state of the
LED changed
3) In the input mode, the inside figures represent the input states of GPIO
Summary
In this lesson, you have learnt how to build the Internet of Things for WebIOPi platform
based on Raspberry Pi and how to control your device remotely on the platform. You can
learn WebIOPi in depth and make full use of your knowledge to make more fun things.