User Manual

16
Storage
Between uses:
 Turn control knob OFF.
 Disconnect LP cylinder
 Store heater upright in an area sheltered from direct contact with inclement weather
(such as rain, sleet, hail, snow, dust, and debris).
 If desired, cover heater to protect exterior surfaces and to help prevent build-up in air
passages.
Note: Wait until heater is cool before covering
During periods of extended inactivity or when transporting:
 Turn control knob OFF.
 Disconnect LP cylinder
 Store heater upright in an area sheltered from direct contact with inclement weather
(such as rain, sleet, hail, snow, dust, and debris).
 If desired, cover heater to protect exterior surfaces and to help prevent build-up in air
passages. Never leave LP cylinder exposed to direct sunlight or excessive heat.
Note: Wait until heater is cool before covering.
Service
Only a qualified service person should repair gas passages and associated components.
Caution: Always allow heater to cool before attempting to service.
5
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assem-
ble, operate, or install the product.
This manual contains important information about the assembly, operation,
and maintenance of this patio heater. General safety information is pre-
sented in these first few pages and is also located throughout the manual.
Keep this manual for future reference and to educate new users of this
product. This manual should be read in conjunction with the labeling on
the product. Safety precautions are essential when any mechanical or pro-
pane fueled equipment is involved. These precautions are necessary when
using, storing, and servicing. Using this equipment with the respect and
caution demanded will reduce the possibilities of personal injury or prop-
erty damage. The following symbols shown below are used extensively
throughout this manual. Always heed these precautions, as they are essen-
tial when using any mechanical or fueled equipment.
PREPARATION
Before beginning assembly of product, make sure all parts are present.
Compare parts with package contents list and hardware contents above. If
any part is missing or damaged, do not attempt to assemble the product.
Contact customer service for replacement parts.
Estimated Assembly Time: 10 minutes
Tools Required for Assembly (not included):
Phillips screwdriver w/ medium blade. Leak Detection Solution.
Store the appliance indoors only if the cylinder is disconnected and re-
moved from the appliance.
A cylinder must be stored outdoors in a well-ventilated area out of the
reach of children. A disconnected cylinder must have dust caps tightly in-
stalled and must not be stored in a building, garage or any other enclosed
area. Use the pressure regulator supplied with the appliance.
CONTINUED