User Manual

8
DANGER
(1) Failure to comply with the precautions and instructions provided with this heater can result in
death, serious bodily injury, and property loss or damage from hazards of fire, explosion, burn,
asphyxiation, and/or carbon monoxide poisoning. Only persons who can understand and fol-
low the instructions should use or service this heater.
(2) Never store propane near high heat, open flames, pilot lights, direct sunlight, other ignition
sources or where temperatures exceed 120 degrees F (49 degree C).
(3) Never install or remove propane cylinder while heater is lighted, near flame, pilot lights, or
other ignition sources or while the heater is hot to the touch.
(4) This heater is red hot during use and can ignite flammable too close to the burner. Keep flam-
mables at least 3 feet from sides & 2 feet from top. Keep gasoline and other flammable liquids
and vapors well away from the heater.
(5) Store the propane cylinder outdoors in a well ventilated space out of reach of children. Never
store the cylinder in an enclosed area (house, garage, etc.). If heater is to be stored indoors,
disconnect the propane cylinder for outdoor storage.
(6) Keep solid combustibles such as building materials, paper, or cardboard a safe distance away
from the heater as recommended by the instructions.
(7) Provide adequate clearances around air openings into the combustion chamber.
(8) Never use the heater in spaces which do or may contain volatile or airborne combustibles or
products such as gasoline, solvents, paint thinner, dust particles, or unknown chemicals.
(9) During operation, the product can be a source of ignition. Keep heater area clear and free from
combustible materials, gasoline, paint thinner, cleaning solvents, and other flammable vapors
and liquids. Do not use heater in areas with high dust content. Minimum heater clearances
from combustible materials: three (2) feet from the sides & two (2) feet from the top.
(10) This heater is a combustion appliance. All combustion appliances produce carbon monoxide
(CO) during the combustion process. This product is designed to produce extremely minute,
non-hazardous amounts of CO if used and maintained in accordance with all warnings and
instructions. Do not block air flow into or out of the heater.
(11) Carbon monoxide (CO) poisoning produces flu-like symptoms, watery eyes, headaches, dizzi-
ness, fatigue, and possibly death. You can’t see it and you can’t smell it. It’s an invisible killer.
If these symptoms are present during operation of this product get fresh air immediately!
(12) For outdoor use only.
(13) Never use inside house or other unventilated or enclosed areas.
(14) This heater consumes air (oxygen). Do not use in unventilated or enclosed areas to
avoid endangering your life.
WARNING Unauthorized repair work by anyone other than the manufacturer or
the authorized SUNHEAT dealer or team member you purchased from is not rec-
ommended. Please contact the company you purchased from or call SUNHEAT at
1-877-467-8643 if you have questions regarding your heater not working properly.
SAVE THESE INSTRUCTIONS
13
OPERATION INSTRUCTIONS
4. Push and release the igniter button until pilot flame is visible through the glass tube
5. Once the pilot is lit, continue to depress the control knob for 30 seconds.
6. If the pilot does not stay lit, repeat steps 4-5.
7. If after repeating steps 4-6 unit does not light, then;
 Push in the control knob and turn counter-
clockwise to “PILOT” (figure 3)
 As you are depressing the control knob,
place long stem Lighter through the glass
tube to light the pilot (figure 4).
 Repeat step 6
8. Push in and turn the control knob to the
“HIGH” then release and turn counterclockwise
to “LOW” (Figure 5)
Note: If pilot fails to remain lit, all valves should be closed and a waiting period of at
least 5 minutes should pass before attempting to light.
If you experience any ignition problem please consult “Troubleshooting”
Caution: Avoid inhaling fumes emitted from the heater’s first use. Smoke and odor from
the burning of oils used in manufacturing will appear. Both smoke and odor will dissipate
after approximately 30 minutes. The heater should NOT produce thick black smoke.
Note: The burner may be noisy when initially
turned on. To eliminate excessive noise from the
burner, turn the control knob to the PILOT position.
Then, turn the knob to the level of the heat desired.
Note: In normal condition, the height of flame is
2/3 height of glass tub under HIGH position. The
height of the flame is 1/3 height of the glass under
LOW position. The flame is stable and bright. No
noise or black smoke. Contrarily it is in abnormal
condition.