Owners manual

ASSEMBLY INSTRUCTIONS

13. Slide Φ8 washers (GG) over the threaded ends

of reflectors spacers (FF). Attach reflector assembly

to head assembly (C). Place Φ8 washers (GG) over

threaded ends of reflector spacers (FF) sticking out

through reflector assembly and secure with wing

nuts (KK).

Note: Do not over tighten.

Hardware Used

14. Screw gas hose (K) and regulator (L) onto propane 14

cylinder (not included). Do not cross-thread.

Place the propane cylinder into the cylinder housing (H),

then close the door (I).Code, CSA B149.1, or propane

storage and handling code, B149.2.

WARNING: Use a standard 20 lb. propane cylinder

only. Use this heater only with a propane vapor

withdrawal supply system. See chapter 5 of the Standard

for Storage and Handling of Liquefied Petroleum Gas,

ANS/NFPA 58. Your local library or fire department

should have this book.

A minimum supply pressure of 0.4 P.S.I. is required for

the purpose of input adjustment for propane gas.

Storage of an appliance indoors is permissible only if

the cylinder is disconnected and removed from the

appliance. A cylinder must be stored outdoors in a

well-ventilated area out of the reach of children. A

disconnected cylinder must have dust caps tightly

installed and must not be stored in a building, garage

or any other enclosed area. The minimum permissible

gas supply pressure of 10 W.C. is required for purpose

of input adjustment. A minimum of 17,000 BTUs per

hour is the required input rating for a heater with a

rating less than full.

The pressure regulator and hose assembly supplied

with the appliance must be used.

The installation must conform with local codes, or in the

absence of local codes, with national fuel gas code,

ANS Z223.1/NFPA54, natural gas and propane

Installation Code, CSA B149.1, or propane storage and

handling code, B149.2.

Reflector Spacer

Φ8 Washer

Wing Nut