Instructions / Assembly

4
FIREPLACE OPERATION
Plug your Infrared fireplace heater power cord into a 120V, 15 amp or 20
amp three bladed outlet.
To Set Flame Brightness: Use the Dimmer button (4) on the control
panel or remote control. The flame brightness control button is used to
increase or decrease the brightness of the flame and ember. Press
once, the brightness will start and keep changing. Press again to set
the desired level.
Remote Control
Control Panel
To Set Flame Brightness: Use the Dimmer button (4) on the control
panel or remote control. The flame brightness control button is used to
increase or decrease the brightness of the flame and ember. Press
once, the brightness will start and keep changing. Press again to set
the desired level.
To Turn the Heater On: Press the
Power button (1) on the control
panel or on the remote control.
To Set the Temperature: Press
the Up or Down button(2) on the
control panel or on the remote con-
trol to the desired temperature.
When desired temperature is
reached, the heater will stop heat-
ing automatically. When the temperature
drops below the desired temperature, the
heater will come on again.
The default display is the set temperature. To
display the room temperature, press and hold
the Up button for 3 (three) seconds, and then
the room temperature will display for 5 (five)
seconds.
Please note: The fan may run up to 2.5
minutes after heating has stopped. This is
NORMAL!
To Set the Heating Level: Press the Heat
button (3) on the control panel or the remote
control to switch between high and low heat
and the corresponding High (H) or Low (L)
LED will be lit. The high heat level uses 1500
watts for rooms up to 1000 square feet. The
low heat level uses 1000 watts for rooms up to
500 square feet.
To Change Between °C and °F: Press the
C/F button (5).
5
FIREPLACE PLACEMENT
Our Infrared Fireplace heater is a very safe and effective room heater. It
produces safe, clean and economical heat by utilizing quartz infrared
heating elements and multiple copper heat exchangers. The heating
process of the Infrared Fireplace heater is similar to the way the sun
warms the earth. The infrared elements warm the copper heat exchang-
ers and the whisper quiet fan distributes the accumulated warmth. This
process is unique among heaters in that it minimizes wasteful heat collec-
tion at the ceiling height of rooms and targets it toward the living space
instead.
To achieve maximum efficiency of the Thermal Wave Portable Infrared
Heater, please consider the following recommendations:
1. Place the Thermal Wave near the center of the home next to a
warmer inside wall with the heat being blown toward the colder out-
side walls of the home. This will allow the thermostat to accurately
moderate the temperature, therefore producing a more even warmth.
2. For best results, do not locate the Thermal Wave Portable Heater in
an area with a high rate of air flow.
3. For maximum efficiency, a 40% (minimum) relative humidity should be
maintained in the heated environment.
4. The Thermal Wave is designed to operate at maximum efficiency up
to the 70-72˚F range. Due to this unique heat concept, a temperature
at 68˚F feels as though it were 72˚F. Similar to a summer heat index,
the moisture in the air holds the heat and transfers it evenly through-
out the entire area.
5. For efficiency, the Thermal Wave Infrared Heater is not recommended
for use in areas with exposed, non-insulated, concrete, or metal walls.
You can use the TW 1500 in any room, whether insulated or not. How-
ever, a non-insulated room will allow for greater heat loss that will im-
pact the effectiveness of the heater.
6. Keep the area around the heater clear of clutter and obstacles to in-
sure free airflow into and out from the heater.