INFRARED ZONE HEATING SYSTEM OWNER’S MANUAL Model No.
PLEASE SAVE THESE INSTRUCTIONS WARNING: READ THIS OWNER’S MANUAL CAREFULLY BEFORE USE. Thank you for choosing a Thermal Wave by SUNHEAT Infrared Zone Heating System. This owner’s manual will provide you with valuable information necessary for the proper care and maintenance of your new product. Please take a few moments to thoroughly read the instructions and familiarize yourself with all the operational aspects of your new heater.
the plug, DO NOT unplug by pulling on the cord. 16. Always unplug the unit before moving or cleaning, or whenever the heater is not in use. 17. Use only for intended household use as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. The use of attachments not recommended or sold by unauthorized dealers may cause hazards. 18. Always use on a dry, level surface. Use on floor only. 19. DO NOT use outdoors. 20.
WARNING: This heater has a voltage rating of 120 volts. The cord has a plug as shown in A. An adapter as shown in C is available for connecting three-blade grounding-type plugs to two-slot receptacles. The grounding lug extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box. The adapter should not be used if a three-slot grounded receptacle is available. DO NOT DEFEAT THE SAFETY PURPOSE OF THE GROUNDED PLUG.
Control Panel RCIN 1 15 ¡ æ 14 ¨ H 77 2 13 High Timer Low Power ECO 3 4 Timer 12 ON/OFF Mode 11 10 9 8 7 6 5 1. Signal-receiving window: For receiving remote control signal. 2. Digital display：Indicate set room temperature or time value according to the timer. 3. Power indication Light：Indicate when the unit connects to power supply. 4. ON/OFF switch button: For power-on or off. 5. Energy-saving mode：The light ‘s on when energy-saving mode goes. 6. Mode button：For select running mode.
Remote Control ON/OFF button: Used for power-on or power-off Temp up button: To make set temperature rise Temp down button: To make set temperature decline Mode button: Used for mode selection °C/°F button: Button for alternating between Fahrenheit and Celsius. Timer button: Used for setting timer and adjust time value of timing PREPARATION Place the heater on a firm, level surface and plug into a grounded 120V 60Hz power outlet, and turn on the power switch in the rear of the unit.
OPERATING INSTRUCTIONS 1. Start and select working mode Turn the heater on by pressing the ON/OFF button on the control panel or by pressing the Power button on the supplied remote control. Once power is off heating element will stop working at first. Fan will prolong working for 3 min to emit plenty of heat inside. This mark will indicate running during the 3 min. Or Select a heat setting. Press the MODE button to toggle between the three heat settings.
Caution! ONLY under power-on mode can you set timer-power-off function. When starting the unit, press the timer button on the control panel. Or Digital display turns set temperature to time value for the timer. Press the timer button more than once, the value will vary from 0 to 12hr (1 hr interval) in circulation. The light is on when timer –power-off is set. 4. Setting timer-power-on Caution! ONLY under power-off mode can you set timer-power-on function.
2. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth. CAUTION: DO NOT let liquid enter the heater. 3. DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater. This may cause damage or deterioration to the surface of the heater. 4. DO NOT immerse the heater in water. 5. Wait until the unit is completely dry before use. 6.
TROUBLESHOOTING If the heater will not operate, please check the following before seeking repair of service: 1. Check if the power cord is plugged into an electrical outlet, if not, plug in. 2. Check if electricity to the main fuse is working. 3. Check if the battery in remote control is in good use, and if the insulating film is pulled out. NOTE: The heater may not be operating if the thermostat is set lower than the room temperature.
LIMITED THREE YEAR WARRANTY WARRANTY: The Company warrants this product to the original purchaser or gift recipient, to be free from defects in workmanship and material under normal use and service, for a period of three years from the date of purchase. LIMITATIONS: ALL WARRANTIES IMPLIED BY LAW, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE EXPRESSLY LIMITED TO THE DURATION OF THE LIMITED WARRANTIES SET FORTH ABOVE.
