Product Specs
Table Of Contents
- BMS002 BT5.2 LE Audio Module
- RF/Analog
- • Frequency spectrum: 2.402 GHz to 2.480 GHz
- • Receive sensitivity: -95 dBm (2 Mbps EDR)
- • Output Power：8±2dBm (BDR) , 6±2dBm (EDR)
- 4±2dBm (BLE1M/2M)
- Audio Codec
- • SBC,AAC, LDAC
- • 24-bit digital-to-analog converter (DAC) with 10
- • 24-bit analog-to-digital converter (ADC) with 95
- • Supports up to 24-bit, 192 kHz I2S digital audio
- 1.DEVICE OVERVIEW
- 3.Power-on/off sequence
- 4. Battery charge specification revision 1.2 (BC1.2)
- 6.Module Description
- 8. Electrical Characteristics
- 9.Recommended Reflow Temperature Profile:
- 10.QR code label information:
- 11.Certification
- 12.Standard Packing Information
- 13.Document History
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
If the FCC identification number is not visible when the module is installed inside another
device, then the outside of the device into which the module is installed must also display a
label referring to the enclosed module. This exterior label can use wording such as the
following: “Contains Transmitter Module FCC ID: 2AMX3BMS002” Or “Contains FCC ID:
2AMX3BMS002”
When the module is installed inside another device, the user manual of the host must contain
below warning statements;
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
The devices must be installed and used in strict accordance with the manufacturer's
instructions as described in the user documentation that comes with the product.
Any company of the host device which install this modular with Limited Single modular approval should
perform the test of radiated emission and spurious emission according to FCC part 15C :
15.247 and 15.209 requirement, Only if the test result comply with FCC part 15C : 15.247 and
15.209 requirement，then the host can be sold legally.