Technical Specs
Table Of Contents
Bluetooth neckband headsets BS007
For FAQs and more information, pleae visit:
SUNITEC BLUETOOTH HEADSET
MODEL: BS007
尺寸:100mmx300mm 3折 风琴折
正面
反面
Step 1: Ensure the headset is ON.
Step 2: Press and hold MF-Button for 5 seconds until LED indicator flashes blue and
red alternately. Once powered on and failed to connect with a phone, it will auto into
pairing mode after 10 seconds.
Step 3: Activate Bluetooth on your phone and select "BS007"
Step 4: The Bluetooth neckband headset is ready for use now
Noted: After the BS007 Bluetooth neckband headsets and a mobile phone have been
paired they will automatically connect with knows mobile phone or Bluetooth device
when turned on next time (Bluetooth activated and in range).
How to use
Button Function Operation
MF-Button
V+
V-
Power On / Off
Answer a call
End a call
Reject a call
Play/Pause music
Voice dialing (Phone feature
like Siri/google assistant)
Redialing last number
Restore to default setting
Volume Up
Previous song
Volume Down
Next song
Slide to ON / OFF
Short press MF-Button once
Short pressMF-Button once
Press and hold MF-Button for 2s
Tap MF-Button once (in music
playing status)
Press and hold MF-Button for
2seconds (in standby mold &
connected with phone)
Double-tap MF-Button
Press and hold V+ / V- for 10
seconds simultaneously
Tap V+ once
Press and hold V+ for 2s
Tap V- once
Press and hold V- for 2s
LED indicator on headset
LED indicator
Headset Status
Voice Guidance
Steady blue Led 1 seconds
Steady blue Led 1 seconds
The red and blue flash
alternately
Blue Led flash once every
6 seconds
Steady red
RED OFF
Red Led flash once every
6 seconds
Blue Led flash once every
1 second
Blue Led flash once every
6 seconds
Power on
Power off
In pairing mold and ready to
connect
Standby mode (a phone or
Bluetooth device has connected
with our BS007)
Battery is charging
Battery is full charged
Low battery
Out of Bluetooth range
Manual disconnect Bluetooth
from BS007
Power on
Power off
Pairing
Connected
N/A
N/A
Low battery
Disconnected
Disconnected
When the battery becomes low, the Led will flash red every 6 seconds and you will
hear voice guidance of "low battery", then you should recharge your BS007. please
charge by using the good quality charger, USB charger or PC USB port. It normally
take about 2 hours to full charge the battery. the Led will indicate red when charging
and off when charging is complete.
Charging requirements: you can plug our supplied USB cable to your own
USB chargers (wall charger/travel charger, etc) with 5V/500Ma-1A or PC USB port.
It is OK to use most mobile phone charger on the market.
Warnings:
1. Please do not overuse this earphone or put it under heavy pressure, keep away
from wet and heat.
2. Keep away from WIFI, router or other high frequency transmitting equipment to
prevent interruption of signal receiving
3. Please use this earphone under its working range(10meters), and the effect
would be better if there is no obstacle between the connected devices
4. Using this Bluetooth earphone to connected any device with Bluetooth function
Technical specifications:
Bluetooth V5.0, Qualcomm chipset, Up to 10 meters (33 feet)
Operating frequency band: 2402~2480MHz unlicensed LSM band
Paired device: Up to 8 paired devices, two active device connected simultaneously
Battery: Built-in 200mAh rechargeable Li-ion battery
Standby time: Up to 250 hours
Talk time: Up to 12-15 hours
Supported profile: HSP, HFP, A2DP, AVRCP, APTX, APTX Low Latency, SBC, AAC
Charging time: approx.2hours
Charger Voltage: DC5.0V, 500mA
Note: The talk and stand by time may vary when using different phones or other
compatible Bluetooth device, usage setting usage style and environments.
The company Sunitec Electronics Limited, declares that products BS007 complies
with the essential requirement of the 2014/53/EU
The declaration of conformity in complete form is available at the headquarters of
Sunitec Electronics Limited.
Product sold in the US and Product sold in the European community
Manufactured by Sunitec Electronics Limited.
MADE IN CHINA
Product Overiew
L
NO
+
-
OFF
Volume-/Previous
Volume+/Next song
Microphone
MF-Button
Answer/end call
Pause/Play/Turn On/Off
USB charging port
How to charge
Declaration of Conformity
Bluetooth Pairing: