Instruction Manual

6
Technical Data
Rated Voltage .................................................120V AC ~ 60 Hz
Motor ..............................................................................13-amp
Max Water Inlet Temperature ...................................104ºF/40ºC
Max Water Inlet Pressure .............................................. 101 PSI
Max Pressure at initial discharge ............................... 2,100 PSI
per CSA internal pressure testing
Rated Pressure under typical load ............................. 1,800 PSI
Max Flow with nozzle open ....................1.65 GPM (6.25 L/min)
at minimum pressure
Rated Flow under typical load ....................1.1 GPM (4.2 L/min)
Foam Cannon Capacity ......................................... 34  oz (1 L)
High-Pressure Hose Length ..................................... 20 ft (6 m)
Power Cord Length .............................................. 35 ft (10.7 m)
Net Weight ........................................................... 17 lbs (7.7 kg)
Unpacking
Carton Contents
• Electric pressure washer
• Top handle
• High-pressure hose holder
• Spray wand protector
• Trigger gun holder
• Cord holder
• 4.8 x 16 screws (7)
• Spray wand
• Trigger gun
• Three (3) Quick-Connect nozzles (0º, 15º, 40º)
• Heavy-duty turbo nozzle
• Utility bristle brush
• Wheel + rim brush
• Needle clean-out tool (included with manual packet)
• High-pressure hose
• Garden hose adapter (female coupler)
• Manual with registration card
1. Carefully remove the pressure washer and check to see
that all of the above items are supplied.
2. Inspect the product carefully to make sure no breakage or
damage occurred during shipping. If you nd damaged or
missing parts, DO NOT return the unit to the store.
Please call the Snow Joe
®
+ Sun Joe
®
customer service
center at 1-866-SNOWJOE (1-866-766-9563).
NOTE: Do not discard the shipping carton and packaging
materials until you are ready to use your new electric
pressure washer. The packaging is made of recyclable
materials. Properly dispose of these materials in
accordance with local regulations.
IMPORTANT! The equipment and packaging materials are
not toys. Do not let children play with plastic bags, foils,
or small parts. These items can be swallowed and pose a
suocation risk!
mWARNING! Do not connect to power supply until
assembly is complete. Failure to comply could result in
accidental starting and possible serious personal injury.
Assembly
Tools required: Phillips head screwdriver
1. Slide the top handle in position on the top of the pressure
washer, and attach using the three screws as shown
(Fig. 1).
2. Attach the high-pressure hose holder and secure using the
four additional screws provided, as shown (Fig. 2).
Fig. 1
Top handle
Screws
Screw