Use and Care Manual

ManualsBrandsSunjoy ManualsGazebosReese 10 ft. x 12 ft. Outdoor Canopy Gazebo with Mosquito Netting

ASSEMBLY INSTRUCTIONS

ITEM# L-GZ798PST-E

IMPORTANT

Production Number: xxxxxxxxxx

Thank you very much for choosing Sunjoy Group.

Please take time to read these instructions thoroughly and follow each step carefully for safe and easy

operation. Keep this manual for future reference.

We would like to hear from you with any comments or suggestions. You can call us toll-free

at 1-866-578-6569 anytime 24 hours / 7 days a week. For further assistance , please write to us at

customer.care@sunjoygroup.com

Summary of content (7 pages)

PAGE 1
ASSEMBLY INSTRUCTIONS ITEM# L-GZ798PST-E IMPORTANT Thank you very much for choosing Sunjoy Group. Please take time to read these instructions thoroughly and follow each step carefully for safe and easy operation. Keep this manual for future reference. We would like to hear from you with any comments or suggestions. You can call us toll-free at 1-866-578-6569 anytime 24 hours / 7 days a week. For further assistance , please write to us at customer.care@sunjoygroup.
PAGE 2
SAFETY INFORMATION: Please read and understand this entire manual before attempting to assemble or install the product. When installing and assembling the item, it is recommended two or more adults are involved. This product is intended for outdoor use only and should be placed on flat, horizontal ground. Ensure enough clearance around the product. Do not use the unit during an electrical storm, as there is a remote chance of getting struck by lightning. Do not climb on top of the item.
PAGE 3
Parts List Description Part NO. QTY CS NO.
PAGE 4
Description Part NO. QTY CS NO. Small Canopy Q 1 P00152B06011 Mosquito netting R 1 P00332B01903 Knob S 12 P90804A07001 Image Hardware Pack 1 Fig.1: Spread the Corner Panel (A) on the ground Fig.2: Insert Long & Short Cross Beam 2(C&E) into Long & Short Cross Beam 1(B&D), tighten withKnob (S). Fig.
PAGE 5
Hardware Pack 2 Fig.4: Insert the Oblique Beam (F) into Bottom Oblique Beam (J1&J2) Fig.5: Insert the Big Roof Connector (K) into another side of the Oblique Beam (F) Fig.6: Insert the assembled Bottom Oblique Beam (J1&J2) into the Corner Panel (A) Fig.7: Insert the Middle Beam （G1&G2 ）into the Bottom Middle Beam (H&I) Fig.8: Insert the Long Middle Beam (G1) and Short Middle Beam (G2) into the big Roof Connector (K), attached the Hook (L) on the big Roof Connector (K) Fig.
PAGE 6
Hardware Pack 3 Part NO. Description AA Plastic Ring BB QTY CS NO. Image 52 PCS P90701B07007 Φ6X180MM“7”Stake 16 PCS P12406C01001 Fig.13: Spread Large Canopy (P) to the roof along the Bottom Oblique Beam (J1&J2), aligning the corners and stretching it to fit. Fig.14: Place Corner Shelves (O) onto Corner Panels (A) as desired. Fig.15: Hang Mosquito netting (R) to the Cross Beams (B, C, D, E), by using Plastic Ring (AA). Fig.
PAGE 7
Care & Maintenance: Our steel components for garden accessories and furniture are treated with rust inhibiting paint that protects it from rusting. However, due to the nature of steel, surface oxidation (rusting) will occur once these protective coatings are scratched. This is not a defect and thus not covered by the warranty. To minimize this condition, we recommend care when assembling & handling the product to prevent scratching the paint.