Use and Care Manual

Fig.4: Insert the Oblique Beam (F) into Bottom Oblique Beam (J1&J2)
Fig.5: Insert the Big Roof Connector (K) into another side of the Oblique Beam (F)
Fig.6: Insert the assembled Bottom Oblique Beam (J1&J2) into the Corner Panel (A)
Fig.7: Insert the Middle Beam （G1&G2）into the Bottom Middle Beam (H&I)
Hardware Pack 2
Fig.8: Insert the Long Middle Beam (G1) and Short Middle Beam (G2) into the big Roof Connector (K),
attached the Hook (L) on the big Roof Connector (K)
Fig.9: Insert the assembled bottom middle beams (H&I) into the Cross Beam (E&C), tighten with Knob (S),
place the Big Canopy (P) to the roof, do not spread it.
Fig.10: Insert the Small Roof Oblique Beam (M) into the Small Roof Connector (N)
Fig.11: Attach Small Canopy (Q) to the small roof along the Small Roof Oblique Beam (M), aligning the corners
and stretching it to fit.
Fig.12: Insert the Small Roof Oblique Beam (M)
into the Oblique Beam (F)