Installation Guide

2 / 9
NOTE: The gazebo’s roof and structure are not guaranteed against extreme weather
conditions (storms, high winds, etc.). If the gazebo is not dismantled for the winter,
snow must be cleaned off regularly. Any damage caused by snow accumulation is not
covered by the warranty.
Care & Maintenance:
Our steel components for garden accessories and furniture are treated with rust
inhibiting paint that protects it from rusting. However, due to the nature of steel,
surface oxidation (rusting) will occur once these protective coatings are scratched.
This is not a defect and thus not covered by the warranty. To minimize this condition,
we recommend care when assembling & handling the product to prevent scratching
the paint. Should any scratching or damage occur, we recommend immediate
touch-up with rust inhibiting paint, which is convenient to purchase from your local shop.
Surface rust can also be easily removed with a very light application of common
cooking oil. If surface oxidation (rusting) occurs and if no measure is taken to prevent
this, the oxidation may start dripping on to deck or patio and caused damaging stains,
which may be difficult to remove. This can be prevented if the above-mentioned
measures are taken to keep the product from oxidizing.
DO NOT REMOVE THE PROTECTIVE FILM ON THE PC TOP PANELS UNTIL
INSTALLATION. MAKE SURE TO PUT THE UV PROTECTED SIDE FACING UP. IT IS A
VERY IMPORTANT PROCEDURE; IF NOT FOLLOWED AS DESCRIBED, YOUR ROOF
WILL NOT BE COVERED BY THE GUARANTY.
GAZEBO ASSEMBLY INSTRUCTIONS
Our clear, easy-to-follow, step-by-step instructions will guide you through the project
from start to finish. The final product will be a quality piece that will give you years of
enjoyment.
All you will need is a screwdriver, a hammer and two ladders of at least 8 feet (2.5 m)
high (not included).
DO NOT assemble this item alone for your safety. Six people are necessary for
smooth & safe installation.
Item identification: For ease of identification, all parts are labeled to correspond to the
Step number in which the part is used.