Installation Guide

ManualsBrandsSunjoy ManualsGazebosSeville Polycarbonate 10 ft. x 12 ft. Top Gazebo With Netting

IMPORTANT

Thank you very much for choosing Sunjoy Group.

Please take time to read these instructions thoroughly and follow each step carefully for safe and easy

operation. Keep this manual for future reference.

We would like to hear from you with any comments or suggestions. You can call us toll-free at

1-866-578-6569 from 8:00 a.m. EST to 8:00 p.m. PST. You can also send the email to

customer.care@sunjoygroup.com

or visit www.sunjoyonline.com

to get tech. assistance or to place

your replacement part order form.

Sunjoy S-GZ604PCO-F Seville Polycarbonate Top Gazebo

Owner’s Manual

Production Number:xxxxxxxx

Summary of content (10 pages)

PAGE 1
Sunjoy S-GZ604PCO-F Seville Polycarbonate Top Gazebo Owner’s Manual IMPORTANT Thank you very much for choosing Sunjoy Group. Please take time to read these instructions thoroughly and follow each step carefully for safe and easy operation. Keep this manual for future reference. We would like to hear from you with any comments or suggestions. You can call us toll-free at 1-866-578-6569 from 8:00 a.m. EST to 8:00 p.m. PST. You can also send the email to customer.care@sunjoygroup.com or visit www.
PAGE 2
Cautions: 1. Keep all children and pets away from assembly area. Children and pets should be supervised when they are in the area of pavilion construction. 2. The area for assembly should not be less than 6 feet from any obstruction such as fence, garage, house, over hanging branches, laundry line or electrical wires. 3. This unit is heavy. Do not assemble this item alone. Four people are recommended for safe assembly. 4. Some parts may contain sharp edges.
PAGE 3
Parts List Post A 4 Stake Slice B 4 C1 2 C2 2 D1 2 D2 2 Corner Beam E 4 Middle Beam F 6 G 4 Left Slot H1 4 Right Slot H2 4 Middle Slot H3 2 “F” Baffle 1 I1 4 “F” Baffle 2 I2 4 “F” Baffle 3 I3 2 Left Arc Support Bar J2 4 Right Arc Support Bar J1 4 Corner Support K 4 Small Roof Cover L 1 Long Decorative Groove 1 Long Decorative Groove 2 Short Decorative Groove 1 Short Decorative Groove 2 Decorative Groove Connector 3
PAGE 4
Roof Connector M 1 Hook N 1 O 4 Corner Cover P1 4 Middle Cover P2 4 Upper Closure plate Q1 4 Middle Closure plate Q2 6 PC Board 1 R1 8 PC Board 2 R2 8 PC Board 3 R3 4 Mosquito Netting S 1 Post Up Connect Piece Hardware Pack 1 AA Bolt M6x15 100 PCS BB Flat Washer M6 116 PCS CC Bolt M6x35 16 PCS DD Bolt M5x12 32 PCS FF M6 Wrench 1 PC 4
PAGE 5
Step1： Fig.1: Attach Stake Slice (B) on Post (A) and fix them tightly by Bolt (AA) and Flat Washer (BB). Fig.2: Attach Decorative Groove Connector (G) to Decorative Grooves (C1&C2&D1&D2) and fix them tightly by Bolt (AA) and Flat Washer (BB). Fig.3: Attach Post (A) to Decorative Grooves (C1&C2&D1&D2) and fix them tightly by Bolt (CC) and Flat Washer (BB).
PAGE 6
P2 Fig.4: Attach Decorative Grooves (C1&C2&D1&D2) to Post (A) from the outside and fix them tightly by Bolt (AA) and Flat Washer (BB). Fig.5: Attach the lower side of Corner Cover (P1) to Decorative Groove (C1,C2, D1&D2) using bolt(DD), and fix the up side using bolt(DD). Fig.6: Attach the lower side of Corner Cover (P2) to Decorative Groove (C1,C2, D1&D2) using bolt (DD), and fix the up side using bolt (DD). Fig.
PAGE 7
Step 2： Fig.9: Use Bolt (AA) and Flat Washer (BB) to lock Corner Beam (E) to Roof Connector (M). Fig.10: Firstly to put Post Up Connect Piece (O) on the top of the Post (A), then use Bolt (AA) and Flat Washer (BB) to lock the bottom of Corner Beam (E), Post (A) and Post Up Connect Piece (O) together. Lock them tightly. Fig.11: Use Bolt (AA) and Flat Washer (BB) to lock Middle Beam (F) to Roof Connector (M). Fig.13 N Fig.
PAGE 8
Hardware Pack 3 AA Bolt M6x15 10 PCS BB Flat Washer M6 10 PCS Step 3： Fig.14: Insert PC Board 3 (R3) into the Gazebo Top, and then insert Middle Slot (H3) and another PC Board 3 (R3) into the Gazebo Top.（Note: “on” side is upper side ） Fig.15: Insert PC Board 1 (R1) into the Gazebo Top, and then insert Middle Slot (H1) and another PC Board 2 (R2) into the Gazebo Top. (Note: “on” side is upper side) Fig.16: Cover the bottom of PC Boards with “F” Baffle (I3).
PAGE 9
Fig.17: Insert Middle Closure plate (Q2) into the bottom of Middle Beam (F) by Bolt (AA) and washer (BB) Fig.18: Insert Corner Closure plate (Q1) into the bottom of Corner Beam (E) by Bolt (AA) and washer (BB) Hardware Pack 3 Φ8*180mm Stake EE 12 PCS D1\D2 Fig.22 C1\C2\ s Fig.19: Attach the mosquito netting (S) to the decorate groove tube（C1\C2\D1\D2）. Fig.20: Connect the Hook on the Mosquito Netting (S) to the “T” shaped hole on the Post (A). Fig.
PAGE 10
Care & Maintenance: Our steel components for garden accessories and furniture are treated with rust inhibiting paint that protects it from rusting. However, due to the nature of steel, surface oxidation (rusting) will occur once these protective coatings are scratched. This is not a defect and thus not covered by the warranty. To minimize this condition, we recommend care when assembling & handling the product to prevent scratching the paint.