Assembly Instruction Summerhouse pergola Item: L-PG080PST
Warnings: 1. Assembly Instructions must be followed. 2. Pegs supplied must be used to hold this pergola in place when upright. WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC. It is not fire proof. The fabric may burn if left in continuous contact with any flame source. This unit is heavy. Do not assemble this item alone. CARE & MAINTENANCE: 1. This pergola is not a permanent structure and should be disassembled & stored away after use. 2.
Parts List Top Bar (1) A 7 Top Bar (2) B 7 Long Side Support Bar (1) C 2 Long Side Support Bar (2) D 2 Short Side Support Bar (1) E 2 Short Side Support Bar (2) F 2 Corner Connector 1 G1 2 Corner Connector 2 G2 2 Post 1 H1 2 Post 2 H2 2 Post Base I 4 Base Protector J 4 Arch Support Frame 1 K 4 Arch Support Frame 2 L 4 Fixity M 8 Small Connector N 4 Beam 1 O 2 Beam 2 P 2 Guideway Bar Q 4 Top Canopy R 1
Hardware Pack Used in Step 1 AA M6x15 Bolt 54 PCS BB M6 Washer 68 PCS CC M6x45 Bolt 14 PCS W M6 Wrench 1 PC Fig.1: Insert Long Side Support Bar (D) to Long Side Support Bar (C), tighten by using Bolt (AA) and Washer (BB).Connect Short Side Support Bar (E & F) in the same way. Fig.2: Insert the assembled Long Side Support Bar and Short Side Support Bar to the “U” shaped plate of Corner Connector (G1/G2), tighten by using Bolt (AA) and Washer (BB). Fig.
Fig.5: Attach Base Protector (J) to Post (H1/H2), fix Post Base (I) to Post (H1/H2) by using Bolt (DD) and Washer (BB). Fig.6: Lift the whole assembled top, insert Post (H1/H2) to Corner Connector (G1/G2). Fig.7: Attach Arch Support Frame (K/L) to Support Bar (C/D/E/F), and tighten by using Bolt (AA) and Washer (BB). Fig.8: Attach the other end of Arch Support Frame (K/L) to Post (H1/H2) by using Bolt (AA) and Washer (BB). Fig.9: Attach the Small Connector (N) to the Guideway Bar (Q). Fig.
