Instructions / Assembly

May 16 Made in China 10 / 13
SET-UP
Your gas fireplace comes ready for gas connection.
1. Place fireplace on any level, outdoor, non-combustible surface.
NOTE: Do not place this fireplace on grass or dirt area as this may
prevent proper safety venting.
2. Open the gas door and place the cylinder inside.
3. Unscrew the battery box as shown in Fig.1. Insert the negative side of the battery (not included) into the bottom of
battery box as shown in Fig 2. Then screw in the battery box as shown in Fig 3.
Fig 1 Fig 2 Fig 3
Note: If the battery of the pulse electronic igniter does not spark replace with a new battery as step 3 above.
Gas Connection
1. Open the door, put the chain and control valve outside. See Fig 4.
2. Put the tank into the tank rack. See Fig 5.
3. Connect the regulator and the tank as per Fig.6. Check for leaks.
4. Secure the tank with the chain. See Fig 7.
Fig 5
Fig 6
Fig 7
Fig 4