Installation Guide

5/9
Made in China
LOCATION
Your gas appliance must be installed on a flat, stable surface, away from any combustible materials or construction.
SET-UP
Your gas appliance comes assembled, ready for a gas connection.
1-
Remove the appliance from container box and place it on any level, outdoor, non-combustible su
rface.
NOTE: Do
not place this appliance on grass or dirt area. This may prevent proper safety venting.
2-
Put the cylinder on the shelf and place them aside by the base, NOTE: minimum distance is 30in
.
3-
Unscrew the battery box as shown in Fig 1.Insert the negative electrode side of the AA battery (not included) into
the bottom of battery box as shown in Fig 2. Then screw the battery box as sho
wn in Fig 3.
No
te: If the battery of the pulse electronic igniter runs out of power, please replace the new battery as above.
GAS CONNECTION
1- Organize the decompression valve, and put the shelf aside by the base. See Fig 4.
2-
Loose the knob on the shelf. See Fig 5-1; Place the gas cylinder on the shelf. See Fig 5-2; Tighten the knob on
the shelf to fix the gas cylinder. See Fig 5-3.
3-
Connect the regulator and the cylinder as Fig.6. Make sure there is no leakage or damage
.
4-
Disconnect the regulator and the cylinder as Fig.
7
5-
Put the Lava Rock (G) on the middle of Base (B), Place 2pcs fire log 2 and 2pcs fire log 3 on the first layer. Se
e
Fig
8.Then place the rest fire log 2 and 4pcs fire log 1 on the second layer. See Fig 9.
6-