Installation Guide

7/9
Made in China
LIGHTING THE BURNERS
1- Make sure control valve is OFF.
2-
Turn on gas tank valve.
3-
Press in and turn control valve knob counterclockwise to LOW to light. S
ee
the
figure to the right.
4-
If burner is lit, continue pressing in the control valve knob for a minute to h
eat
the
thermoc
ouple.
5-
When control valve knob is released, the burner should be lit. If not, turn
control valve knob clockwise to OFF. Wait for 5 minutes then start with step 3
above.
6-
Press in and turn control valve knob to desired heat output, LOW ~ HIGH
.
NO
TE: While in use, the burner flame should be mainly blue in appearance with a small amount of yellow. The
flame can be identified by the following figure.
W
arning: Lighting the fireplace improperly could lead to an unsafe condition.
7-
Press in and turn the control valve knob clockwise to OFF to shut down fireplace. Close the gas cylinder valve
when the fireplace is not in use.
(CAUTION: Do not kink flexible gas hose. If it is kinked, a gas leak could occur.)
STORAGE AND MAINTENANCE:
To obtain the best performance from your fireplace, you must perform the following storage and maintenance
activities on a regular basis:
 Allow at least 35 minutes for the fireplace to cool down after use, before disconnecting and removing the gas
cylinder
.

Store the gas cylinder in a dry, well-ventilated and sheltered area protected from inclement weather and dus
t,
out o
f the reach of children, and not in a building, garage or any other closed
area.

The fireplace may be stored indoors only if the cylinder is disconnected and remov
ed.
OFF
HIGH
MAX
BAS
ARRET
LOW