Installation Guide

Page 3 of 4 Version: 8912 Made in China
F
i
g
,
1
F
i
g
4
Step 4: Connect Connector frame (B) to
Base (A) by M6 × 15 screws (CC), M6 flat
washer (EE) See Fig 4
Step 5: Connect Triangle stator (C ) with
Connector frame (B) by M6×55screw
( DD), M6 flat washer (EE), M6 nut (FF);
See Fig 5
Step1. Connect Decorative Top Ball (H) by
Upper Stator (H), M6×10screw (AA), M6 flat
washer (EE) and M6 nut with cap (GG);
Connect Lower Stator (I) and Decorative
Frame (F) by M6 flat washer (EE)and M6 nut
with cap (GG). See Fig 1
Step 2: Connect roof frame (E) and
assembled top by M6×25screw (BB), M6 flat
washer (EE) and M6 nut with cap (GG);
Tighten two opposite sides first and leave the
rest two corners during this step. See Fig 2
Step 3: Connect the left two corners by
attached the assembled top to screen(D) thru
roof frame(E). Use M6 × 25 screws (BB), M6
flat washer (EE) to tighten up.See Fig 3
Step 6: Fasten Triangle stator (C) to Connector
frame (B) as per right image.. Screen (D) by
M6×15screw (CC), M6 flat washer(EE); screw
M6 wrench ( WW )and M6 Hex wrench (NN)
tightened , but do not over tighten. See Fig 6