Installation Guide

STEP 2
Fig.5: Install the Pothook (O) onto the Big top connector (M); then insert the Long slanting bar (J), Short mid top
bar (K) and Long mid top bar (L) into the Big top connector (M). (Here one person is needed to support the Top
connector M).
Fig.6: Insert the Long slanting bar (J) into the Corner mandril connector (H) & (I).
Fig.7: Install the Short (Long) mid top bar K (L) on the connector of the top of the beam frame with bolt (EE) and
flat washer (BB) and nut (FF).
Fig.8: Insert the Small top pole (P) into the Small top connector (N) as a small top.
Fig.9: Put the Large canopy (S) on the big top; do not spread it. Then install the assembled small top on the Long
slanting bar (J) with bolt (EE), flat washer (BB) and nut (FF). Place the Small canopy (T) on the small top and
tighten.
AA
M6X15 bolt
12 PCS
BB
M6 flat washer
44 PCS
GG
M6X45 bolt
16 PCS
HH
M6X25 bolt
16 PCS
II
Φ8X180 peg
12 PCS
Hardware Pack 3