Installation Guide

Fig.1：Attach Connector 4 (G) to Long Beam (E1, E2) with Bolt (AA) and Flat Washer (BB). (same as Short beams).
Fig.2: Put Stake Cover (K) under Post(J）and secure them together with Bolt (AA) and Flat Washer (BB).
Fig.5: Attach Support 2 (I) onto Post (J), the assembled long and shorts beams (E1, E2, F1, F2) with Bolt (AA) and
Flat Washer (BB).
Fig.6: Attach Support 2 (H) to the asse mbled long and short beams (E1, E2, F1, F2) Bolt (AA) and Flat
Washer (BB).
Fig.3: Connect Long Beam (E1, E2), Post (J) and Connector 3 (D) together with Bolt (CC) and Flat Washer (BB).
Do not tighten them at this step.
Fig.4: Insert Short Beam (F1, F2) into the gap between Post (J) and Connector 4 (D) and secure them with Bolt (CC)
and Washer (BB). Tighten all the bolts and washers at Fig. 3.