Installation Guide

ManualsBrandsSunjoy ManualsStorage & OrganizationIvy 10 ft. x 10 ft. White Iron Pavilion Pergolas with Flower Pots

Versailles Pavilion

Assembly Instructions

L-PG050PST

NOTE: Please read instructions prior to assembly. It is recommended to use 8 people for assembly.

 When assembling and using this product, basic safety precautions should always be followed to reduce the

risk of personal injury and damage to equipment.

 For outdoor use only.

 Keep instructions for future reference.

 Ground stakes are included for use on dirt and grass.

 Check all bolts for tightness before and during usage.

WARNING: Assemble as per instructions only. Do not alter the construction of the pavilion. Children and pets

should be supervised when they are in area of the pavilion.

Notes before assembly: Permanent installation recommended. For ease of cleaning and safety, do not

assemble less than 6 ft / 1.8 m from any obstruction such as a fence, garage, house, overhanging branches,

laundry line or electrical wires. Install on level ground. To ensure safe use of this pavilion, it may be necessary

to install the pavilion permanently into poured concrete blocks or railroad ties or similar using suitable bolts.

Consult a qualified contractor or representative at your local hardware store or home center.

Please check your local regulations prior to permanently installing this item. Some municipalities have

restrictions and requirements.

Summary of content (5 pages)

PAGE 1
Versailles Pavilion Assembly Instructions L-PG050PST NOTE: Please read instructions prior to assembly. It is recommended to use 8 people for assembly.  When assembling and using this product, basic safety precautions should always be followed to reduce the risk of personal injury and damage to equipment.  For outdoor use only.  Keep instructions for future reference.  Ground stakes are included for use on dirt and grass.  Check all bolts for tightness before and during usage.
PAGE 2
NOTE: Gently set parts on a level, non abrasive surface. Verify that there are no missing parts. Parts List ： Part# Qty. A 4 Hardware list: Part Des. Diagram Part# Qty. Part Des.
PAGE 3
ASSEMBLY INSTRUCTIONS PART 1: UPPER DOME ASSEMBLY Step 1: Assembly Instructions of Circular Rail Fig.1 DOWN \ Attach Top Rail 1 (D1) to Top Rail 2 (D2) with 4 Bolts (a), Flat washer (c) and Acorn Nut (b). See Fig. 1. The side with DOWN arrows should face down during assembly. Repeat for the other 6 top rails. Top Rail (D1) and Top Rail (D2) should alternate until circle is complete. Step 2: Assembly Instructions of Finial and Dome Fig.2 Fig. 3 Screw Finial Ball (F2) to Finial (F1).
PAGE 4
PART 2: POLE AND FENCE ASSEMBLY Step 1: Assembly Upper Poles to Dome Fig. 4 ( 8 people are needed for this step) Four people hold the 4 Upper Pole (B) in vertical position and using 4 people lift assembled dome over 4 poles. Insert the Upper pole (B) pre-attached bolt into the Top Rail (D2) and attach with Flat washer (e) and Nut (d). Secure the Upper Pole (B) with 4 Flat Washers (c) and 4 Bolts (a). See. Fig. 4. Repeat for remaining 3 Upper Poles (B). Fully tighten hardware. Fig.5 UP Fig.
PAGE 5
PART 2: FINAL ASSEMBLY Step 1: Attach Side Rails to Poles Attach Side Rail (C1, C2) to Bottom Pole (A) with Bolts (a) and Flat Washers (c). See Fig. 7. Repeat for remaining 3 Bottom Poles (A). Fully tighten hardware. Fig.8 Fig.7 Fig.9 Step 2: Assembly of Ground Stakes and Planters Attach each Hanging Planter (G) to a Top Rail (D1). See Fig. 8. Top Rail (D1) (Fig. 8) CARE INSTRUCTIONS Place Ground Stakes (f) through the base of the Bottom Pole (A) into the ground on soft surface. See Fig. 9.