Owner Manual













































Hardwa rePack1
AA M6*15 Hexagon Bolt 40PCS
BB M6 Washer 40PCS
Z M6 Wrench 1 PC
Fig.1: Insert long side Support bar(C) to long side support bar (D) by using bolt (AA) and washer (BB).
Fig.2: Insert the assembled long side support bar (C), short side support bar (E) to the corner connector
(G1), by using bolt (AA) and washer (BB). Connect the assembled long side support bar (D),
short side support bar (E) to the corner connector (G2), by the same way.
Fig.3: Attach the rail connector (N) to long side support bar(C, D) by using bolt (AA) and washer (BB).
Fig.4: Put the rings (P) on the rail beam (O2), then insert one end of rail beam to the rail connector (N)
Fig.5: Tighten the rail beam (O2) on the long side Support bar(C) by using bolt (AA) and washer
(BB).Tighten the rail beam (O1) on the long side support bar (D) by the same way. Attention: the ring
that placed on the edge of the beam must be hanged behind the pilot pin as shown.