User Manual

ManualsBrandsSunlight Supply ManualsLightingQuest Dual 110 Overhead Dehumidifier

Installation, Operation and Maintenance Instructions

This manual is provided to acquaint you with the

dehumidier so that installation, operation and

maintenance can proceed successfully. Ultimate

satisfaction depends on the quality of installation

and a thorough understanding of this equipment.

The dehumidier is built around tested engineering

principles and has passed a thorough inspection for

quality of workmanship and function.

Quest Dry

Installation, Operation and Maintenance Instructions

4201 Lien Rd Phone 608-237-8400

Madison, WI 53704 Toll-Free 1-800-533-7533

www.QuestProtect.com sales@QuestProtect.com

– Read and Save These Instructions –

Specications subject to change without notice.

Quest 110 Dual

Water Removal Rates (Pints/Day)

110 pints 80˚F, 60% (AHAM)

quest

Asset Protection and IAQ Solutions

quest

Providing 110 pints of water removal per day at standard

rating conditions (80ºF/60%RH), the Quest 110 Dual

will effectively control humidity while using only 7.1

amps/115V.

Features:

• High capacity

• High efficiency

• Environmentally friendly

• Patent pending dual-air distribution

TS-879

05/14

Patent Pending Dual-Air Distribution

Summary of content (14 pages)

PAGE 1
Quest Dry 110 Dual Installation, Operation and Maintenance Instructions – Read and Save These Instructions – This manual is provided to acquaint you with the dehumidifier so that installation, operation and maintenance can proceed successfully. Ultimate satisfaction depends on the quality of installation and a thorough understanding of this equipment. The dehumidifier is built around tested engineering principles and has passed a thorough inspection for quality of workmanship and function.
PAGE 2
Quest 110 Dual Installation, Operation and Maintenance Instructions Table of Contents Safety Precautions...................................................... 3 1. Intended Application(s)........................................... 4 2. Registration ........................................................... 4 3. Specifications ..................................................... 4 4 . Installation ........................................................... 5 4.1 Remove Compressor Shipping Support.....
PAGE 3
Quest 110 Dual Installation, Operation and Maintenance Instructions Safety Precautions Read the installation, operation and maintenance instructions carefully before installing and operating this device. Proper adherence to these instructions is essential to obtain maximum benefit from your Quest 110 Dual indoor air quality system. READ AND SAVE THESE INSTRUCTIONS • The device is designed to be installed INDOORS IN A SPACE THAT IS PROTECTED FROM RAIN AND FLOODING.
PAGE 4
Quest 110 Dual Installation, Operation and Maintenance Instructions 1. Intended Application for Quest 110 Dual The Quest 110 Dual is intended for use in light commercial structures: however, the unit can be placed in almost any setting where dehumidification is desired. Use in highly corrosive applications and pool areas may void warranty. The Quest 110 Dual works most effectively between 56° and 95°.
PAGE 5
Quest 110 Dual Installation, Operation and Maintenance Instructions 4. Installation CAUTION! Remove compressor shipping tie from the unit. Failure to remove shipping tie will cause excess vibration to be transmitted to the frame. 4.1 Remove Compressor Shipping Support The Quest 110 Dual uses a compressor to power the refrigeration system. To protect the compressor and refrigeration system during shipping a plastic tie wrap secures it to the units frame.
PAGE 6
Quest 110 Dual Installation, Operation and Maintenance Instructions 4.2B Duct Outlet (fig. 2) Dehumidification performance can be modified by adding an outlet duct to circulate air. Figure 2: Installation in humid area with outlet ducting. Output of Dehumidified Air Front View Input of Humid Air 4.2C Remote Area, w/Outlets Ducted (fig.
PAGE 7
Quest 110 Dual Installation, Operation and Maintenance Instructions CAUTION! For proper drainage, the unit must be mounted so the drain outlet is at least 4” above the floor drain, and must be fully supported under the base. 4.4 Installing Feet Included with your Quest 110 Dual are four leveling feet. It is important to level the unit for proper draining. Figure 1: Four leveling feet. Installing Leveling Feet See Figure 2 for installing leveling feet. 1. Lay down a protective pad (pillow, blanket, etc.
PAGE 8
Quest 110 Dual Installation, Operation and Maintenance Instructions CAUTION! The Quest 110 Dual requires a drain trap. Creating a drain trap allows a small amount of water to build up in the trap area of the clear hose. This prevents air from back flowing through the hose and into the dehumidifier; essentially causing the unit to backflow water out of the corners of the machine.
PAGE 9
Quest 110 Dual Installation, Operation and Maintenance Instructions Approximate Humidity Levels Per Setting: 20% to 30% Relative Humidity “Normal” 45% to 55% Relative Humidity (Recommended) “Humid” 80% to 90% Relative Humidity 4035413 “Drier” 4031882 The dehumidifier will run until the relative humidity (RH) is reduced to the humidity control dial setting. Quality humidity meters are available from the factory and are recommended to accurately monitor humidity levels.
PAGE 10
Quest 110 Dual Installation, Operation and Maintenance Instructions 8. Service WARNING! Servicing the Quest 110 Dual with its high pressure refrigerant system and high voltage circuitry presents a health hazard which could result in death, serious bodily injury, and/or property damage. Only qualified service people should service this unit. 8.
PAGE 11
Quest 110 Dual Installation, Operation and Maintenance Instructions 8.2 Troubleshooting FOR THE USER: If the unit does not work properly, please check the following: — Is the unit unplugged? — Is power to outlet on? (check switch, if applicable) — Is circuit breaker tripped? — Is humidity control set? (turn to “ON”) — Is air flow restricted? (check air filters and grill) If none of the above, call dealer or 1-800-533-7533. FOR THE HVAC PROFESSIONAL: No dehumidification.
PAGE 12
Quest 110 Dual Installation, Operation and Maintenance Instructions Evaporator coil frosted continuously, low dehumidifying capacity. 1. Dirty air filter or air flow restricted. 2. Defrost thermostat loose or defective. 3. Low refrigerant charge. If none of the above has fixed the issue, call technical support at 1-800-533-7533. 9. Service Parts List Call your dealer or 1-800-533-7533.
PAGE 13
Quest 110 Dual Installation, Operation and Maintenance Instructions 11. Wiring Diagram quest Asset Protection and IAQ Solutions 1-800-533-7533 13 www.QuestProtect.com sales@QuestProtect.
PAGE 14
Quest 110 Dual Installation, Operation and Maintenance Instructions Quest 110 Dual Dehumidifier Limited Warranty WARRANTOR: Therma-Stor LLC 4201 Lien Rd Madison, WI 53704 Telephone: 1-800-533-7533 WHO IS COVERED: This warranty extends only to the original end-user of the Quest 110 Dual dehumidifier, and may not be assigned or transferred.