User Manual
Instructions for Use
1. Mount Apollo 3 near equipment to be operated,
away from water, mist, etc.
2. Plug equipment to be controlled into the Apollo 3.
3. Do not exceed 10 amps.
4. Plug the Apollo 3 into a 120 volt outlet.
5. Equipment will cycle one (1) minute “On”
and four (4) minutes “O” until power is defeated.
6. To reset Apollo 3, unplug timer & then plug
back into outlet. Timer will always start with the
“On” cycle.
Controller Specications
Size: 4"H x 2"W x 2.5"D
Weight: 1 lb.
Voltage Input: 120 volts
Voltage Output: 120 volts
Maximum Amperage: 10 amps
Hertz: 60 Hz
On Time: 1 minute
O Time: 4 minutes
Operating Temperature: 35
o
to 125
o
F | 2
o
to 53
o
C
Storage Temperature: 32
o
to 135
o
F | 0
o
to 57
o
C
Cord Set: Wall mount
www.titancontrols.net
For technical assistance call us at
1-888-80-Titan or 1-888-808-4826.
Apollo 3
Fixed Cycle Timer
Easy Guide
Controlling a Drip Feed
Controlling an
Aeroponics System
Controlling an
Ebb & Flow System
VANCOUVER, W ASHINGTON U.S.A.
Apollo 3
Apollo 3
Apollo 3
Apollo 3
Apollo 3
Apollo 3
Apollo 3
Apollo 3
Apollo 3