RFID (μ-Chip) Handheld Reader User Manual Ver. 1.0 Sunlit System Technology Corp., 2006.03.
1.Hardware 1.1 Reader Outlook (unit: mm) 1 2 3 4 1: Graphic mode LCD Screen 2: Power Button 3: Scan key 4: Battery Set 1.2 Specification 1.2.1 FSTN LCD Module: 1.3 inch screen，Graphic mode，101×67 dot， 37.5×31.6 (mm) 1.2.2 Power Button 1.2.3 Scan Key 1.2.4 Warning signal by built-in buzzer when fail in reading. 1.2.5 Size AA batteries *3（only Alkaline or Ni-MH Battery） 1.2.
Card 1.2.7 Working Temp: up to 50℃ 1.2.8 Storage Temp: up to 80℃ 1.2.9 Power saving by automatically shut-down 1.3 Module/Antenna Specification 1.3.1 Voltage: DC 2.4 ~ 5V 1.3.2 Power Consumption: Standby: With LED Backlight 70 ~ 80 mA @4.0V Without LED Backlight 20 ~ 30 mA @4.0V Scanning: 130 ~ 150mA @4.0V (Average) 1.3.3 Frequency: 2.40 ~ 2.4835 GHz 1.3.4 Impedance: 50 ohm 1.3.5 Antenna Gain: 0dBi 1.3.6 Radiation: Direction 1.3.7 Polarization: Semi Circular 1.3.8 Beam Angle Degree: 90° 1.3.
2.7 When reader detects an illegal tag, LCD screen will display ”警告! 偵測到不合法標籤” for 7 seconds with3 alarms. 2.8 Press Power Button continuously for 3 seconds to turn-off reader. 2.9 Battery Power Status on screen.
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
