Installation Guide
INSTALLATION INSTRUCTIONS
OUTDOOR
WAll
liGHT
Please read carefully and save these instructions, as you
may
need
them
at
a
later date.
CAUTION
Turn
off
the main
power
at the circuit breaker before installing
the
fixture, in
order
to
prevent possible shock.
GENERAL
All electrical connections must
be
in accordance
with
local and National
Electrical
Code
{N.E.c.) standards.
If
you are unfamiliar
with
proper electrical
wiring connections obtain
the
services
of
a qualified electrician.
Carefully unpack light fixture and hardware
bag
from
box, and make sure
that
no parts are missing by referencing
the
illustrations on the installation
instructions.
INSTALLATION AND ASSEMBLY
1.
Screw
the
fixture screws {14)
into
the mounting bracket{3), and
thread
the
hex nuts{15) into fixture screws. Secure the fixture
screws by tightening hex
nut
against
the
mounting bracket.
2.
Pull
the
power
supply wires
out
from
the
OUTLET
BOX
{1).
Attach the mounting bracket
{3)
to
the
outlet
box{1) using
mounting screws{2).
3.
Make
wire
connections, connect
the
black supply wire
{5)
to
black fixture wire {11),
white
supply wire {4)
to
white fixture
wire{10) and
the
fixture ground wire{12)
to
supply ground
wire{6) using wire nuts {7). Wrap
all wire connections
with
electrical tape
for
secure connection.
4.
After wires are connected,
tuck
them
carefully inside
the
outlet
box. Position back plate{13) over the
outlet
box and feed
fixture screws
{8)
through
two
holes
of
the
back plate until they protrude
out
from
the
back plate approximately
1/4"
and secure using
two
cap nuts{14).
5.
Installation
is
complete. Turn on power at
the
circuit breaker.
Turn
light switch
on
to
operate this fixture.
I
~-
After installing
the
fixture, caulk upper 2/3
of
wire connection enclosure
to
1.
f·
3.
4.
5.
I
6.
7-
i
mounting surface. Leave
bottom
1/3
un-caulked
for
drainage
of
any
water
that
might leak
into
the enclosure. The manufacturer recommends a non-drying
exterior
caulking material. A good example.
is
a clear silicone rubber sealant
for
exterior
use.
OUTLET
BOX
{NOT
INCLUDED)
8. #?-32
FIXTURE
SCREW
MOUNTING
SCREW
9.
#S-32
HEX
NUT
10.
ifHITE
FIXTURE
WIRE
MOUNTING
BRACKET
WHITE
SUPPLY
WIRE
11.
BLACK
FIXTURE
WIRE
BLACK
SUPPLY
WIRE
12.
RIXTURE
GROUND
WIRE
I
SUPPLY
GROUND
WIRE
13.
BACK
PLATE
WIRE
NUT
14.
CAP
NUT
I