Instructions / Assembly

ManualsBrandsSunlite ManualsFlush Mount Ceiling Lights49.7 in. White Flush Mount with Frosted Plastic Shade and No Bulbs Included Selectable CCT

CEILING MOUNTING

TOOLS REQUIRED:

WARNING:

• Wire Cutters

• Electrical Tape

• Wire Strippers

• Phillips Screwdriver

V2022-A

Anchor

Be sure the electricity to the wires you are working on is shut oﬀ. Either remove the fuse or turn the circuit oﬀ.

Self-tapping Screw

HARDWARE INCLUDED:

U-Clip

V-Hook

PG Gland

EE FF

Note: These instructions do not cover all details or variations in equipment nor do they provide for every possible

situation during installation operation or maintenance.

1. Open each of the lens release latch (B) and remove

the lens. (Fig 1)

2. Press the two LED panel retaining clips together

while lifting up the LED panel to release the LED

panel from the housing. (Fig 2)

3. Connect the supply cord wires by routing the cord or

conduct through the adapter entrance into the driver

compartment. Connect the Line(L), Neutral (N), and

Ground (G) leads into the push-in slots as marked on

the LED driver unit. ( Fig 3).

4. Measure the distance between the mounting adapter

clips (D) and mark desired location on mounting

surface. Drill and secure both mounting adapter clips

onto mounting surface and secure the ﬁxture by

snap ﬁtting the ﬁxture over the mounting adapter

clips. (Fig 4)

WARNINGS & CAUTIONS: Risk of ﬁre or electric shock, avoid ﬁre or electric shock. Turn oﬀ the power at fuse or circuit breaker box before installation and maintenance to

avoid electric shock. Before installation thoroughly review encolsed installation manual. This ﬁxture is suitable for 120-277 Volts fused circuits,This product must be

installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. If you do not

have suﬃcient electrical wiring experience, please consult a qualiﬁed electrician. Consult a qualiﬁed electrician to ensure correct branch circuit conductor. Do not make or

alter any open holes in an enclosure of wiring or electrical components during installation. If the product is damaged, do not attempt installation and do not use. Not for

emergency lighting. Suitable for operation in ambient not exceeding 40°C. Operating temperature -20°C - 40°C(-4°F - 104°F). Suitable for wet locations.

85260-SU | LFX/VTS/4’/MW/3SCT | VAPORPROOF FIXTURE

P3 Wire NutFF

Cover

Fixture Body

Summary of content (2 pages)

PAGE 1
85260-SU | LFX/VTS/4’/MW/3SCT | VAPORPROOF FIXTURE WARNINGS & CAUTIONS: Risk of ﬁre or electric shock, avoid ﬁre or electric shock. Turn oﬀ the power at fuse or circuit breaker box before installation and maintenance to avoid electric shock. Before installation thoroughly review encolsed installation manual.
PAGE 2
5. For 0-10V dimming , follow the wiring directions as in (Fig 5). 6. The end users may adjust the color temperature and lumen output respectively by the two DIP switch buttons integrated into the driver. Each DIP switch is accommodated with 3 option (left, middle and right) corresponding to 3 color temperatures and 3 powers respectively, which can perform the desired color temperature and lumen output combination.