Manual

Sunnex HM Light Service & Installation Manual

2.3 Transportation and Storage

This light is packaged in card board and should be transported protected from moisture. The light

should be stored in a dry environment and room temperature.

Transportation and storage temperature: -5°F / -20°C to 140°F / 60°C

Humidity < 95%

2.4 Bulb replacement

1. Lamp front, part#: 18018

2. Bulb support, part#: 18291

3. Color filter, part#: 18676

4. MR 16 bulb, part#: 18562

5. Lamp back, part# 18016

6. Screws, part#: 4475057

1. Unplug lamp from power source and wait at least one hour for lamp to cool.

2. Loosen the connecting cable from the transformer to make sure that lamp is not supplied with

voltage.

3. Unscrew the three screws from back cover of the lamp.

4. Remove the halogen cold light bulb from its socket.

5. Replace the damaged halogen cold light reflector. Only Sunnex cold light reflector with part. no.

18562 must be used. NOTE! Make sure the cold light reflector is clean and without fingerprints.

6. Refit the back cover, with the three screws. NOTE! The color filter must not be removed, since the

color temperature of the lamp depends on this. A damaged color filter must be replaced immediately.

CAUTION! Be sure the lampshade components are properly seated when screws are tightened!

2.0 Assembly Instructions