Edited with the trial version of Foxit Advanced PDF Editor To remove this notice, visit: www.foxitsoftware.com/shopping Mini Stepper with Exercise Bands Item NO. 012 For Customer Service, please contact: support@sunnyhealthfitness.
Edited with the trial version of Foxit Advanced PDF Editor To remove this notice, visit: www.foxitsoftware.com/shopping Important Safety Information We thank you for choosing our product. To guarantee your safety and health, please use this equipment correctly. Please read the information below carefully before using this equipment. 1. It is important to read this entire manual before assembling and using the equipment.
Edited with the trial version of Foxit Advanced PDF Editor To remove this notice, visit: www.foxitsoftware.com/shopping Part List : Main frame 1pc Exercise bands 2pcs NO.
Edited with the trial version of Foxit Advanced PDF Editor To remove this notice, visit: www.foxitsoftware.com/shopping Assembly Instructions: 1. Take out the stepper main frame from the box and lift one pedal up first (make sure cable is secure on the wheel). 2. Then adjust the knob clockwise to its place. Note: "+" means higher step range and "-" means lower step range. 3. Attach the exercise bands to the ring on the stepper (as seen in steps below). 4. Assembly completed.
Edited with the trial version of Foxit Advanced PDF Editor To remove this notice, visit: www.foxitsoftware.com/shopping Adjusting the Rope Length To Lengthen Rope To Shorten Rope Put down one side of the rope; then pull the bottom of rope down. (repeat until rope is at desired length) This adjustment decreases the tension. Push up the rope from the bottom; pull one side of the top rope. (repeat until rope is at desired length) This adjustment increases the tension.
Edited with the trial version of Foxit Advanced PDF Editor To remove this notice, visit: www.foxitsoftware.com/shopping Computer Functions: MODE/RESET: Press the red "mode" button to select each function. Hold the button down for 3 seconds to reset to zero. SCAN: Press "mode" button to select "scan", then it will automatically scan through each function in sequence. TIME: Automatically accumulates workout time when starting exercise. CALORIES: Automatically accumulates calories consumed during exercise.
Edited with the trial version of Foxit Advanced PDF Editor To remove this notice, visit: www.foxitsoftware.com/shopping 3) Insert the new battery in by tool/finger. Please make sure the anode (with words) is on the top. 4) Cover the battery with the plastic cap. 5) Connect the wire onto the meter. 6) Insert the meter on Base Frame (1). 2. Please use (1) LR44, 1.5V battery. 3. The monitor is auto-powered. It turns on when exercise begins, and it turns off when no movement is made between 4 to 5 minutes.