Edited with the trial version of Foxit Advanced PDF Editor To remove this notice, visit: www.foxitsoftware.com/shopping TWIST STEPPER NO. 045 For Customer Service, please contact: support@sunnyhealthfitness.
Edited with the trial version of Foxit Advanced PDF Editor To remove this notice, visit: www.foxitsoftware.com/shopping Important Safety Information We thank you for choosing our product. To guarantee your safety and health, please use this equipment correctly. Please read the information below carefully before using this equipment. 1. It is important to read this entire manual before assembling and using the equipment.
Edited with the trial version of Foxit Advanced PDF Editor To remove this notice, visit: www.foxitsoftware.com/shopping Description Part No.
Edited with the trial version of Foxit Advanced PDF Editor To remove this notice, visit: www.foxitsoftware.com/shopping Assembly Instructions 1. Install the LCD computer(2) on Base Frame(4). 2. Lift one pedal all the way up, then hook the Cable(6) on the Wheel (5) and press the pedal down. 3. Tighten the Adjustment Knob(1) onto the Base Frame(4). 4. If using the Exercise Bands (3), please screw the rope onto the hook (please see below instructions). Rope Assembly Instructions 1.
Edited with the trial version of Foxit Advanced PDF Editor To remove this notice, visit: www.foxitsoftware.com/shopping Operating Instructions 1. Please follow and read the instructions before assembling and using the equipment. Any other kinds of improper use are strictly prohibited. 2. To operate your stepper, make sure the cable is connected to the groove of the pulley which is located under the baseframe. 3. Place and operate your stepper on a flat level and dry surface. 4.
Edited with the trial version of Foxit Advanced PDF Editor To remove this notice, visit: www.foxitsoftware.com/shopping Meter Functions Function Button : Press red button to select functions of time, count, total count, calories. Hold the button for 4 seconds to have a total reset (except TOTAL COUNT). SCAN : Press “mode” key to select “scan”. This function will automatically scans through all the functions displayed on the bottom line of the monitor.