Use and Care Manual

STEP 4:
Connect Pedals L/R (11) onto the Left and Right Crank Arms (20 and 21).
(Before you begin, immobilize the crank arms by turning the tension control
adjuster all the way to the right).
NOTE: Pedals L/R (11) are marked, L for the (left pedal) and R for the (right
pedal).
Left Pedal: align the left pedal, Pedal L (11) with the Left Crank Arm (20) at 90
degrees. Gently insert the pedal into the crank arm, turn the pedal
counter-clockwise as tightly as you can with your hand. Tighten and secure
with (15mm) spanner wrench.
Right Pedal: align the right pedal, Pedal R (11) with the Right Crank Arm (21)
at 90 degrees. Gently insert the pedal into the crank arm, turn the pedal
clockwise as tightly as you can with your hand. Tighten and secure with (15mm)
spanner wrench.
There is a Bottle Holder (26) (when you received it already assembled with
Bottle Holder Clamp (48), Nut For Bottle Holder (32) and Bolt For Bottle
Holder (25)) you can mount it on top of Handlebar (23). Then tighten
clamp screws.
Assembly Instruction
IMPORTANT:
Read instructions
carefully, failure to
do so may cause
permanent damage
to your bike.
23