Use and Care Manual

ASSEMBLY INSTRUCTIONS
STEP 1:
Remove the preassembled 4 Bolts (No. 14) and 4
Flat Washers (No. 13) from the Front Stabilizer
(No. 2) and Rear Stabilizer (No. 3).
Attach the Front Stabilizer (No. 2) and Rear
Stabilizer (No. 3) to the Main Frame (No. 1) with 4
Bolts (No. 14) and 4 Flat Washers (No. 13).
Tighten and secure with Allen Wrench (A). Make
sure the Foot Levelers (No. 11) are on the bottom
and the transportation wheels facing up at the front
of the bike.
6
STEP 2:
Remove the preassembled 4 Allen Bolts (No. 23),
4 Flat Washers (No. 13) and 4 Spring Washers
(No. 24) from Handlebar Post (No. 26). Attach the
Handlebar (No. 4) to the Handlebar Post (No. 26)
using 4 Allen Bolts (No. 23), 4 Flat Washers (No.
13) and 4 Spring Washers (No. 24). Tighten and
secure with Allen Wrench (A).
Remove the preassembled 4 Phillip Screws (No.
27) from Top Cover (No. 25A). Insert Handlebar
Post (No. 26) through Lower Handlebar Cover
(No. 25B). Slide the Lower Handlebar Cover (No.
25B) to the top of the Handlebar Post (No. 26).
Use Phillip Screws (No. 27) to attach the Top
Cover (No. 25A) to the Lower Handlebar Cover
(No. 25B) so the Handlebar (No. 4) and
Handlebar Post (No. 26) are in between the
Covers (No. 25A and No. 25B).
Loosen Pop-Pin Knob (No. 8), pull the pin, and then
insert the handlebar assembly into the Main Frame
(No. 1). Make sure the pin settles into the desired
hole and secure the Knob (No. 8).