Use and Care Manual

7
ASSEMBLY INSTRUCTIONS
STEP 1:
Attach 2 Adjusting Pads (No. 5) and 2 Hex
Nuts (No. 6) to the Rear Stabilizer (No. 3) by
using Wrench (No. 88).
Unscrew the 4 Hexagon Socket Head
Screws (No. 8) with Allen Wrench (No. 87),
remove the 4 Flat Washers (No. 7), 2
Shipping Tubes (No. 35) from the Main
Frame (No. 1).
Attach the Front & Rear Stabilizer (No. 2&
No. 3) to the Main Frame (No. 1) using 4
Hexagon Socket Head Screws (No. 8), 4
Flat Washers (No. 7). Tighten and secure
with the Allen Wrench (No. 87).
NOTE: You may discard the Shipping Tubes
(No. 35) or save them for future packaging or
transportation.
STEP 2:
IMPORTANT! Read instructions carefully,
failure to do so may cause permanent
damage to your bike.
Before installation, please make sure you have
the Left Pedal (No. 15L) in hand. Align the
Left Pedal (No. 15L) with the Left Crank (No.
12L) at 90° and gently insert the Left Pedal
(No. 15L) into the Left Crank (No. 12L).
Screw the Left Pedal (No. 15L) COUNTER-
CLOCKWISE into the Left Crank (No. 12L).
Tighten and secure with Wrench (No. 89).
Align the Right Pedal (No. 15R) with the
Right Crank (No. 12R) at 90 ° and gently
insert the Right Pedal (No. 15R) into the
Right Crank (No. 12R). Screw the Right
Pedal (No. 15R) CLOCKWISE into the Right
Crank (No. 12R). Tighten and secure with
Wrench (No. 89).