Use and Care Manual

13
RACE MODE
Press and hold MODE for 2 seconds to enter RACE mode.
1. TARGET: the preset CADENCE.
2. In STOP mode, press SET key to enter the TARGET setting in stop mode Press SET to increase
the CADENCE five at a time. The setting change is 15………110→115→120→15→
↑←←←←←←←←←←←↓
3. The setting range of 15 -120 (Preset value is 60 CADENCES. It equals six bars)
4. Each bar equals 10 CADENCE. Total is 12 bars.
Each arrow equals 10 CADENCES (1-10 CADENCES displays one arrow, 11-20 displays two). The
maximum arrows displayed is 12.
This down arrow next to the bicycle icon will be displayed when the current CADENCE is more than
the TARGET CADENCE. The bicycle icon will be displayed during exercise mode.
PULSE
To measure the pulse, press MODE until meter is on the PULSE function. Hold the contact pads
for at least 5 seconds to measure your pulse. This value is for reference only. It cannot be used as
the basis for medical treatment.
BATTERY: This monitor uses two AAA batteries. If the display appears incorrectly or becomes
difficult to read, please install new batteries. Always change both batteries at the same time. Do
not mix battery types and do not mix old and new batteries. Dispose batteries according to your
state and regional guidelines.
CURRENTCADENCE TARGET CADENCE
When Current CADENCE is less than Target CADENCE, the
up arrow next to the bicycle will be displayed.