Use and Care Manual

6
STEP 3
Remove the pre-assembled 3 Nylon Nuts (No.
51) and 3 Flat Washers (No. 50) from the back
of the Seat (No. 68) with Spanner (No. A).
Attach the Seat (No. 68) to the Seat Tube (No.
67) with 3 Nylon Nuts (No. 51) and 3 Flat
Washers (No. 50) that were removed. Secure
and tighten with Spanner (No. A).
Remove the pre-assembled 2 Carriage Bolts
(No. 69), 2 Flat Washers (No. 50), 2 Cap Nuts
(No. 4) and 2 Spring Washers (No. 3) from the
Backrest Tube (No. 70) with Spanner (No. A).
Attach the Backrest Tube (No. 70) to the Seat
Tube (No. 67) with 2 Carriage Bolts (No. 69), 2
Flat Washers (No. 50), 2 Spring Washers (No.
3) and 2 Cap Nuts (No. 4) that were removed.
Secure and tighten with Spanner (No. A).
Remove the pre-assembled 4 Screws (No. 74)
and 4 Flat Washers (No. 75) from Backrest (No.
77) with Allen Wrench (No. B). Then attach
Backrest (No. 77) to Backrest Tube (No. 70)
with 4 Screws (No. 74) and 4 Flat Washers (No.
75) that were removed. Secure and tighten with
Allen Wrench (No. B).