Instruction Manual

5
Assembly Instructions
Step 1
Connect the front stabilizer (3) and rear stabilizer (2) to the main frame (1) with the nylon
locknuts (4), arc washers (5) and carriage bolts (6).
Step 2
Pull the tension wire (14) through the handlebar post (11) and take it out from the front
tension hole of the post; then connect the extension wire (13) with sensor wire (12), insert the
handlebar post (11) onto main frame (1) and lock it tightly with arc washers (5) and screws
(18). Connect the tension controller (15) with tension wire (14), then lock the tension
controller (15) on the handlebar post (11) tightly with flat washers (16) and screws (17).
Important note: Protect the cable inside from damage when completing this step.