Owners manual

9
STEP 2: ATTACHING THE SPINDLE BAR
Insert the Spindle Bar (No. 42) through the Right Swing Bar (No. 29) and Wave
Washer (No. 35) into the main frame, then through Wave Washer (No. 35) and into
Left Swing Bar (No. 27). Put a “D” Shape Washer (No. 32) & a Spring Washer (No.
31) on both sides of the Spindle Bar, tighten both ends using the Hinge Screws (No.
30). Note: Before you tighten the Hinge Screws (No. 30), ensure the D Shape
Washers (No.32) are fully onto the Spindle Bar (No.42).
Insert the Right Hinge Bolt (No. 9) through the Wave Washer (No.35) and the hole of
the Right Pedal Tube (No. 21), screw the Right Hinge Bolt “Clockwise” into the
Crank Arm (No. 51) then slide the Spring Washer (No. 3) onto the Right Hinge Bolt
(No. 9) and secure the bolt with the Right Lock Nut (No. 8).
Repeat this assembly process for the Left Side.
*Important Note: Left Hinge Bolt (No. 1) has reversed threading, when assembling
the Left Side, you must screw the Left Hinge Bolt “Counter-Clockwise” to tighten*.
ATTENTION:
The Right and Left Hinge Bolt (No. 9 & No. 1) must fully penetrate the nylon ring
inside the Pedal Tube (No. 21 & No. 19) & the Right and Left Crank (No. 51). This will
ensure the stability and durability of the Sunny Flywheel Elliptical Trainer.
In order to install hinge bolt properly, keep it perfectly straight as the bolt goes through
the pedal tubing and the crankshaft. If the hinge bolt is connected to the crankshaft at
an angle, damage to both the hinge and the crankshaft may occur.