Use and Care Manual

7
We value your experience using Sunny Health and Fitness products. For assistance with parts or
troubleshooting, please contact us at [e-mail] or 1-877-90SUNNY
(877-907-8669).
14
99
15
10
11
11
11
18
18
19
19
19
13
98
61
14
99
#10 d8*Φ20*2*R16 2PCS
#19 M8*18 6PCS
#18 d8*Φ16*1.5 4PCS
#102 S5 1PC
#104 S13-14-15 1PC
#16 M5*40 1PC
#11 d8 6PCS
17
#15 d5*Ф20*R15*1.5 1PC
16
14
D
B
C
17
99
16
15
99
A
17
99
61
99
13
98
14
STEP 2:
Remove 6 Bolts (No. 19), 2 Arc Washers (No.
10), 6 Spring Washers (No. 11), and 4
Washers (No. 18) from Main Frame (No. 61)
using Allen Wrench (No. 102).
Connect Sensor (No. 98) with Trunk Wire (No.
13) as shown in picture A. Pull out the Lower
Tension Wire (No. 99) from the hole of Main
Frame (No. 61), then insert the Lower
Tension Wire (No. 99) into the bottom hole of
the Handlebar Post (No. 17) and go out
through the side hole of the Handlebar Post
(No. 17) as shown in picture B.
Attach Handlebar Post (No. 17) to Main
Frame (No. 61) using 6 Bolts (No. 19), 2 Arc
Washers (No. 10), 6 Spring Washers (No.
11), and 4 Washers (No. 18) that were
removed. Tighten and secure with Allen
Wrench (No. 102).
Note: Do not clip the wires when assembling
the Handlebar Post (No. 17).
Remove 1 Bolt (No. 16) and 1 Arc Washer
(No. 15) from Tension Control Knob (No. 14).
Check the Tension Control Knob (No. 14) is
at level 8 (highest resistance) to ensure the
wire is the longest. Connect Tension Control
Knob (No. 14) with Lower Tension Wire (No.
99) as shown in picture C, then back the Lower
Tension Wire (No. 99) into Handlebar Post
(No. 17).
Note: When backing the Lower Tension Wire
(No. 99) into Handlebar Post (No. 17), the
direction should be correct as shown in picture
D.
Attach Tension Control Knob (No. 14) to
Handlebar Post (No. 17) using 1 Bolt (No. 16)
and 1 Arc Washer (No. 15) that were removed.
Tighten and secure with Spanner (No. 104).