INCLINE SLIDE ROWER SF-RW5720 USER MANUAL IMPORTANT! Please retain owner’s manual for maintenance and adjustment instructions. Your satisfaction is very important to us, PLEASE DO NOT RETURN UNTIL YOU HAVE CONTACTED US: support@sunnyhealthfitness.com or 1- 877 - 90SUNNY (877-907-8669).
IMPORTANT SAFETY INFORMATION We thank you for choosing our product. To ensure your safety and health, please use this equipment correctly. It is important to read this entire manual before assembling and using the equipment. Safe and effective use can only be achieved if the equipment is assembled, maintained and used properly. It is your responsibility to ensure that all users of the equipment are informed of all warnings and precautions. 1.
EXPLODED DIAGRAM 2
PARTS LIST No. Description Spec. Qty. No. Description Spec. Qty.
ASSEMBLY INSTRUCTIONS #35 M8 2pcs #64 2pcs A 2pcs STEP 1: 36 64 35 38 39 Remove the preassembled 2 Bolts (No. 35), 2 Washers (No. 64) and 2 Sleeves (No. 38) attached to the Rod (No. 39). Insert Rod (No. 39) through the Front Stabilizer (No. 40). Place Sleeve (No. 38) on both sides before attaching the Pedals (No. 36). Using Wrench (A), secure Pedals (No. 36) 40 by using 1 Washer (No. 64) and 1 Bolt (No. 35) on each side (as shown in picture). 36 36 STEP 2: Insert the Pedal Strap (No.
#34 M8 4pcs #59 4pcs #7 M8 4pcs 31 B STEP 4: Assemble the Handle Bar-L (No. 30) onto the Lower Slide Rail (No. 43) using 2 Washers (No. 59), 2 Nuts (No. 7) and Bolts (No. 34). Tighten using Spanner (B). Use these same instructions to attach the Handle Bar-R (No. 31) 30 onto the Lower Slide Rail (No. 43).
EXERCISE COMPUTER FUNCTION KEY: MODE: To select the function you want. Hold the key for 4 seconds and CNT TIME CAL values reset. FUNCTIONS AND SPECIFICATIONS: SCAN -- Automatically scan through each function between ①TIME ②CAL ③TOT.CNT. TIME -- Auto-memorize the workout time while exercising. COUNT-- Accumulate the steps while exercising. CALORIES -- Auto-memorize calories amount consumed while exercising. TOTAL CNT (TOT.
ADJUSTMENTS ADJUSTING THE BALANCE Before using your product, check the balance of the product to ensure that it is safe for use. Put the product on a flat, even surface is ideal. If you find that the product is slightly uneven, you may adjust the product to compensate for uneven ground. To do so,rotate the end caps on the stabilizers until they're even with the surface. Please refer to the drawing below. Please adjust the end caps if there is a slight imbalance problem caused by uneven ground.