Instructions / Assembly

Page 5 / 5 P0003CR 05/2022
SAFETY STATEMENTS & WARNINGS
Any modication to the product or failure to follow recommended care will void the product warranty.
• Operate the pump in freshwater only.
• Do not use bleach or corrosive chemicals to clean any components of the unit.
• Do not charge the solar panel using AC voltage power; it is intended ONLY for DC voltage power.
• Do not use this product to pump flammable liquids.
• Do not use pump with water above 50
°
C (122
°
F) and never at or below 0
°
C (32
°
F).
• Do not allow any components to freeze. During freezing weather, dry every component and store in a warm, dry indoor location.
• Do not strike the solar panel.
• Do not lift the pump by the power cable.
• Altering of this product or changing components is prohibited.
Solar Panel 3W
Operation Voltage 9V DC
Max. Water Flow 250 LPH
Max. Water Lift 1.2M
Water Projection Height 0.7M Max.
LED Light (optional) 4 LED White
Cable Length 5M
Battery
Lithium
7.4V-2000mAh
SPECIFICATIONS
Remote Control RC
Parameters 3V/180mAh
Working Temperature 32°F - 140°F
Working Humidity 0% - 95%
Battery CR2032
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Any changes or modications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment o󰀨 and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit di󰀨erent from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure
condition without restriction.
WARNING!
Manufacturer and seller expressly disclaim any and all liability from personal injury, property damage
or loss, whether direct or indirect, or incidental, resulting from the incorrect attachment, improper use,
inadequate maintenance, or neglect of this product.