Instructions / Assembly

02/2020PH004-3
STEP 7
Unscrew the nut on Quick Link (O) and
hang the link on Eye Bolt (AA).
Hang the assembled chair by placing
Closed S-Hook (N) in Quick Link (O).
Screw the nut on the quick link closed,
ensuring it is tightly fastened.
STEP 8
Align Armrest (M) with the holes on the
side of chair.
Loosely connect the top of Armrest (M) to
the floating chair using 1x M8x30 Bolt (X),
as shown.
Run 1x M8x30 Bolt (X) through the bottom
of Armrest (M), then through Safety Strap
(Z), and into the side of the floating chair,
as shown.
Tighten armrest hardware and repeat this
step to attach the second armrest.
STEP 9
Unravel Rope (Q) and fold in half to find the
center-most point of the rope.
Beginning at the footrest, attach Seat Web
(P) to the floating chair by running Rope
(Q) through the eyelets of the seat web and
around the chair frame.
Tips:
To help keep the rope length even on both
sides, switch between the left and right side every
few eyelets.
After initial installation of the seat webbing, start
back at the footrest and pull the rope every few
eyelets to ensure the seat webbing remains taut.
Once seat web is taut, wrap excess rope
to the chair frame, above the frame brace,
leaving enough rope to tie/knot the ends.
Page 5 / 6