Instructions / Assembly

DSL-667

PARTS:

Step 1: Attach the legs (Part A) to the lower shelf (Part C) using four

of the included bolt sets (Hardware 1). Please note that the

end of the legs that has the screw holes for Step 2 need to be

up.

Step 2: Attach the corner supports (Part B) to the screw holes on the

tops of the legs (Part A) using the remaining 8 bolt sets

(Hardware 1). Please note that the end of the corner support

with the screw hole closest to the edge attaches to the leg.

PAGE 1
DSL-667 PARTS: Step 1: Attach the legs (Part A) to the lower shelf (Part C) using four of the included bolt sets (Hardware 1). Please note that the end of the legs that has the screw holes for Step 2 need to be up. Step 2: Attach the corner supports (Part B) to the screw holes on the tops of the legs (Part A) using the remaining 8 bolt sets (Hardware 1). Please note that the end of the corner support with the screw hole closest to the edge attaches to the leg.
PAGE 2
Step 3: Attach the two side rails (Part D) to the two end rails (Part E) using twelve of the screws (Hardware 2). Please note that the support ridge needs to be on the inside bottom of this structure. Step 4: Place the box made in Step 3 into the corner supports (Part B) from Step 2. Use the remaining 16 screws (Hardware 2) to secure into place. Step 5: Place the three shelves (Part F) into the box from Step 3. Please note that the bottoms of the shelves have the support slats.
PAGE 3
Step 6: Once the unit is assembled, it is ready to be used and placed in your preferred location.