Owners manual

DW-520

Step 1) Connect the pump to the hose on the inside of the fountain.

Step 2) Connect the LED lighting cord, located inside the fountain, to the transformer.

Step 3) Run power cords through the back of the fountain and slide the back panel into place.

Step 4) Fill your fountain with water (approximately 2.5 gallons), making sure the pump is fully submerged.

Step 5) Plug the power cords into power outlets.

PAGE 1
DW-520 Step 1) Connect the pump to the hose on the inside of the fountain. Step 2) Connect the LED lighting cord, located inside the fountain, to the transformer. Step 3) Run power cords through the back of the fountain and slide the back panel into place. Step 4) Fill your fountain with water (approximately 2.5 gallons), making sure the pump is fully submerged. Step 5) Plug the power cords into power outlets.
PAGE 2
IMPORTANT CARE NOTICE • • • • • Fill fountain with sufficient water to ensure the pump is fully submersed. Clean and top-off the water on a regular basis. Always turn off power before cleaning and maintaining the pump. Never allow the fountain pump to run dry as this will cause damage and void the warranty. It’s not recommended to leave the fountain running constantly. We suggest turning the fountain off when not present. WINTER CARE • • • During winter never allow ice to form in the bowls.