Installation Guide

ASSEMBLY

Read carefully and understand assembly before beginning.

Do not fully tighten bolts until instructed to do so.

Page 2 / 3

STEP 1

A: 1

D: 2

1: 2

Do not fully tighten any bolts until after Step 4 is complete.

STEP 2

B: 1

2: 4

3: 4

STEP 3

A: 1

1: 2

STEP 4

C: 1

2: 6

3: 6

• Align Bottom Bar (D) with Side Panel (A). Loosely

secure by hand-tighten M6x30mm Bolt (1).

• Repeat to loosely fasten the remaining bottom bar to

the opposite side.

• With the ledge facing upward, and flush with the side panel,

secure Bottom Panel (B) to the bottom bars using four

M5x25mm Bolts (2) and four M5 Nuts (3).

• Fasten remaining Side Panel (A) to the bottom bars by

hand-tightening two M6x30mm Bolts (1).

• Secure Back Panel (C) to the rear of the side panels using

six M5x25mm Bolts (2) and six M5 Nuts (3).

Do not fully tighten any bolts until after Step 4 is complete.

06/2021

NOTE:

Side Panels install

with the tubular frame on the

outside, screen on the inside.

LWT-B

Tighten all bolts after this step is complete.