Instructions / Assembly

Page 2 / 2
1. Carefully snap or slide Foot (E) onto the curved edge of Leg (C)
as shown.
2. Align the spring button on the straight side of Leg (C) with the
hole in Top Frame (A). Press the button and slide the leg onto
the support until the button snaps through the hole. Repeat on
the opposite side of the top support.
3. Repeat Step 2 for the other side of the stand.
4. Align the holes on the curved sides of Legs (C) with the spring
buttons on X-Support (B). Press the button and slide the leg
onto the support until the button snaps through the hole. Repeat
until all legs are secured.
5. Place 1 S-Hook (D) into the top of each Top Support (A).
6. Ensuring the ropes are not twisted, hand Hammock Chair (F)
on the S-hooks.
HH-HCHAS 1/2021
ASSEMBLY
TROUBLESHOOTING
• If the stand seems unstable, make sure it is on a level surface, and the feet are correctly distributed.
• If a spring button does not engage during assembly, it may be misaligned or stuck. Check to make sure the button is
properly aligned with the corresponding hole. If the button is stuck, use a thin, small tool to help release the button
from the tube in which it is installed.
USE & CARE
• SAFE USE: Swinging, bouncing, jumping and other excessive movement while using this product could result in
serious injury.
• CHILDREN: Supervise children at all times. Do not allow children to play or sleep in hammock chairs.
• STORAGE: Store indoors when not in use. A cool, dry location is recommended to prevent damage from exposure to
moisture and sunlight.
• INSPECT: Ensure the stand is assembled correctly and all spring buttons are intact before each use. Do not use the
hammock chair if the ropes, fabric, or stand show signs of weakness.
• SCRATCHES: The powder-coating is tough and durable, but even under normal use, some scratching is inevitable.
Scratches can be repaired with rust-resistant paint. NOTE: painting the stand will void the product warranty.

CLEANING
SPOT CLEAN/HAND-WASH ONLY
DO NOT USE BLEACH OR FABRIC SOFTENERS
LAY FLAT TO DRY
HAMMOCK: Spot clean with a damp cloth.
For more stubborn stains, hand-wash in a bathtub or kiddie pool using mild soap and a soft-bristled scrub brush. Soaking
may be required for heavily soiled fabric or ropes. Keep the wooden spreader bars, metal components out of the water
as much as possible.
Thoroughly rinse all soap residue. Air-dry on a at surface to prevent the ropes from stretching. The ropes may shrink
slightly while drying but will stretch back out with use.
STAND: Use a soft, damp cloth to wipe down the stand.