Installation Guide
IF-FSB 07/2020
Operaon
WARNING
remote control and touch panel to no longer function.
MASTER SWITCH
The master power switch must be turned ON (—) for the unit to operate. The unit will make a short alarm
sound to indicate it is ready to use. If no sound is heard, the unit may not be plugged in, the circuit breaker
may have tripped, or there is a malfunction.
Turn the master switch OFF (O) to shut o electric supply.
• Remove the battery housing cover from the back of the remote.
• Paying attention to the positive and negative terminals, gently insert two new 'AA'
batteries (not included).
• Replace the battery housing cover.
• NOTE: Promptly remove expelled batteries. Do not mix old and new batteries; mixing
batteries could cause the acid inside the batteries to leak, damaging the remote.
REMOTE
explosion. Dispose of batteries at your local hazardous material processing center.
Methods of Operaon
This electric replace can be operated by the CONTROL PANEL, located on the bottom right side of the
replace, or by the battery-powered REMOTE CONTROL (batteries not included).
The operation and functions of the two methods are the same.
Before operating, please review the IMPORTANT SAFETY INFORMATION on Pages 2 and 3, and heed all
warnings.
Ensure the circuit breaker(s) for the power supply are turned on.
Once the appliance has been plugged into a properly grounded electrical outlet, it is ready to operate.
NOTE: In the event of a power failure, the appliance will lose its memory function and will reset to factory mode
when the power returns.
The Master Power Switch is located on the front top right side of the appliance.
NOTICE
press the buttons too quickly. Give the unit time to respond to each command.
Page 10 / 13