Owners manual

ManualsBrandsSunnydaze Decor ManualsFountains & Pumps4 Tier Octagon Pineapple Outdoor Water Fountain 64 Inch Tall

Part Description Quantity Part Description Quantity

A Base Pedestal 1 G Third Lage Pedestal 1

B Large basin 1 H Third Large basin 1

C Pump 1 I Small pedestal 1

D Board 1 J Small basin 1

E Second pedestal 1 K Fountain Topper 1

F Second large basin 1

64" 4-Tier Octagon Pineapple Water Fountain (LZH-063)

Summary of content (5 pages)

PAGE 1
64" 4-Tier Octagon Pineapple Water Fountain (LZH-063) Part Description Quantity Part Description Quantity A Base Pedestal 1 G Third Lage Pedestal 1 B Large basin 1 H Third Large basin 1 C Pump 1 I Small pedestal 1 D Board 1 J Small basin 1 E Second pedestal 1 K Fountain Topper 1 F Second large basin 1
PAGE 2
SAFETY PRECAUTIONS This fountain is intended for outdoor use only. Place your fountain in a location where any water spills or splashing will not reach any other electrical equipment or cause damage. Choose an appropriate location before installing the fountain. DO NOT lift or push/drag the water basin to relocate the fountain when it’s filled with water. Empty the water basin before lifting. Excessive weight or pressure on any of the fountain sections may cause it to tip or fall over.
PAGE 3
Fig 1 Fig 2 Fig 3 Fig4 Fig5 Fig 6 Fig 7 Fig8 Fig 9 Fig 10 Fig 11 ASSEMBLY INSTRUCTIONS Step 1: Place the base pedestal (A) and the large basin (B) on a level surface Step 2: Route the pump (C)’s power cord downwards through the resin tube in large basin (B). Lay the pump (C) in the bottom of the large basin (B).And then route the pump (C)’s power cord through the base pedestal (A), the cord exits through the slot in the bottom of base pedestal (A).(pls refer to the fig.
PAGE 4
pedestal (E) to the blocks on the large basin as shown in Fig,insert the second large pedestal(E) and twist clockwise to lock in place securely.(pls refer to fig 3.) Step 4: Route the water tube of the fountain topper (K) downwards through the middle hole of the small basin (J), then align the fountain topper (K) with the small basin (J). Make sure matching the slot under the fountain topper (K) to the blocks on small basin (J) as shown in Fig4.
PAGE 5