Instructions / Assembly

3.) Turn (Part A) BED Upside down.
4.) Attach (PART J) REAR AXLE SUPPORT
ASSEMBLY to rear of bed using (PART T)
M8X20 CARRIAGE BOLTS, (PART O) M8
WASHERS and (PART P) M8 NYLON
NUTS.
5.) Attach (PART K) Left and Right REAR
AXLE BRACES to (PART A) BED using
(PART T) M8X20 CARRIAGE BOLTS
(PART O) M8 WASHERS AND (PART P)
NYLON NUTS per side.
6.) Attach (PART G) the YOKE and FRONT
AXLE SUPPORT ASSEMBLY (PART F)
by loosening middle nut to slide Yoke onto
long bolt. THEN Attach FRONT STRUT
(PART H) to long bolt and tighten nut.
7.) Attach (PART I) FRONT AXLE
CONNECTION BAR using (PART S) M8 x
20 HEX BOLTS, (PART O) M8 WASHERS
and (PART P) M8 NYLON NUTS. Insert
PIN of YOKE into middle hole of PART I
secure with washer and COTTER PIN
(PART V) Tighten bolts fully.