Installation Guide

FLC 04/2023 Page 2 / 3
ASSEMBLY
Review all information and understand assembly before beginning.
Nylon
Insert
STEP 1
A: 2
E: 1
STEP 2
F: 2
J: 2
K: 2
STEP 3
B: 1
C: 1
STEP 4
D: 3
G: 6
H: 6
I: 6
Slide Axle (E) through the holes on the bottom of
Base Panels (A).
Firmly secure two Wheels (F) to the axle using two
M12 Washers (J) and two M12 Lock Nuts (K).
Slide Handle (B) onto the back of the base panels.
Slide Log Retainer (C) onto the front of the base
panels.
Loosely secure one Brace (D) to the bottom of the
log cart by hand-tightening two M8x40mm Bolts (G),
two M8 Washers (H) and two M8 Lock Nuts (I).
Loosely secure the two remaining braces to the front
and back of the cart, as shown.
Fully tighten all hardware using included Spanners
(L).
IMPORTANT: Lock nuts must be installed with the nylon insert on the outside.
Tools are required to fully tighten lock nuts, failure to properly tighten the lock nuts may
result in product malfunction or personal injury.
IMPORTANT: Ensure the wheels
are installed in the correct direction.